Installation...
CONNECT TO A DRAINAGE SYSTEM...
WARNING
●Connect your dishwasher drain hose to pipes which connect to the foul drain system, and not to surface water drains.
IMPORTANT NOTES For the correct operation of your dishwasher, it is essential to comply with the following information.
Standpipe
Fit the hose to the standpipe hook which can be found in the machine.
Ensure that the hose is not pushed too far down the standpipe.
DO NOT position the stand- |
|
| 120 | |
|
| min | ||
pipe near an electrical outlet. |
|
|
|
|
|
|
|
| |
ENSURE that the drain hose is routed as shown in the diagram.
The standpipe should be connected to:
a)A discharge
b)An external gulley OR
c)A sink waste.
The standpipe should have a bore of at least 38mm (11/2"). It should be installed as shown, have a trap fitted and must discharge into the same drain system as your household sink.
It must NOT be connected to a surface water drain.
Sink Waste System
For under sink drainage:
Before connecting the drain hose, remove any internal restrictions - This will prevent a build up of debris which could cause a blockage.
Remove any restrictions from the waste spigot and ensure that the sealing bung is removed. The hose should be routed, such that it is raised to a minimum height of 800mm (31/2")
Note: Ensure the sink outlet pipe has a minimum diameter of 32mm.
1.Untie the end of the GREY drainage hose from the rear of the appliance.
2.Reposition ‘Hooked End Support’ as required along GREY drainage hose.
3.If fitting an under sink waste disposal unit, cut out the membrane, bung or blanking plug.
4.Attach the GREY drainage hose to the under sink waste disposal unit securely, using the clip and rubber tube supplied.
Ensure the drain hose is securely attached, to prevent it coming away while the machine is in use and causing a flood.
5