Installation, Choose a Location, Adjust the Feet

Installation...

Follow the Installation Instructions, making sure the Dishwasher is correctly installed.

When installing the Dishwasher, carry out tasks in the following order:

-choose a location.

-level the appliance (adjusting the feet).

-connect to a drainage system.

-connect inlet hose to water supply.

CHOOSE A LOCATION...

The choice of location for your appliance will influence its performance.

●Position where possible on a solid floor. Vibration may occur with a wooden floor.

●Take care with vinyl floor coverings. The weight of the appliance may cause indentations in some vinyl floor cover- ings.

●For your safety and to comply with IEE regulations, you should not install your appliance in a bath or shower room.

Seek professional advice if you wish to do so.

●Ensure sufficient space is allowed for the appliance.

●Ensure the electrical socket and water taps are easily accessible and that the water supply can be isolated if neces- sary. Do not use an extension lead or multiple plug for connection to the elec- trical socket.

●If your dishwasher is underneath a work surface with a hob. You must

add thermal insulation to the top of the machine.

ADJUST THE FEET...

It is essential that the door is closed and latched before stabilising the dishwasher. Ensure that the rear feet are adjusted so that the product is not sitting on the base of the machine. Adjust either clockwise or anti-clockwise as necessary to level.

Then adjust either of the two front feet clockwise or anti-clockwise as necessary until all feet are in contact with the floor to avoid the machine from rocking and is level to within 2˚

The door must be aligned centrally with the sides of the cabinet to ensure the door seal is correctly located.

Note: If the appliance is not stabilised the door may be off centre and make the machine unstable.