Bose L1 Model II manual Connecting the B1 bass module, Bass Module Out

EnglishDansk DeutEspañolchDank FrançaisDeutschItliano NederlandsEspañol FrançaisSvenska Italiano Nederlands Svenska

SYSTEM SETUP

Connecting the B1 bass module

Figure 7

B1 bass module

You can place the B1 bass module either vertically or horizontally on the floor. It fits neatly bewteen the legs of the power stand.

1.Plug one end of the B1 bass module cable into one of the B1 connectors. Rotate the plug clockwise to lock it in place. You should hear a soft click as it locks.

2.Plug the other end of the cable into the Bass Module Out connector on the power stand. Rotate the plug clockwise to lock it.

Note: To disconnect a B1 cable, slide back the metal tab on the body of the plug, rotate the plug counterclockwise, and pull it out of the connector.

B1 bass module cable

Bass Module Out

CAUTIONS:

•DO NOT connect a B1 bass module to two power stands at the same time.

•DO NOT connect any bass module other than the B1 to the power stand.

•DO NOT substitute the supplied cable with a 2-wire speaker cable. Use only the supplied B1 bass module 4-wire cable to connect the B1 bass module to the power stand. The power stand uses the signals on two of the wires to automatically sense how many B1 bass modules are connected.

11