Bose L1 Model II manual Adding a PackLite power amplifier model A1 optional

Page 22

Svenska

Nederlands

Italiano

FrançaisSvenska

NederlandsEspañol

FrançaisDeutschItliano

DeutEspañolchDank

EnglishDansk

SYSTEM SETUP

Adding a PackLite® power amplifier model A1 (optional)

Using a PackLite® power amplifier model A1 allows you to add one or two additional B1 mod- ules to your system. Refer to the A1 owner’s guide for detailed operating instructions.

1.Make sure the A1 amplifier power switch is OFF.

2.Plug one end of the supplied ¼" TRS cable into the Bass - Line Out connector on the power stand. Plug the other end into the INPUT connector on the A1 amplifier.

3.Connect a B1 bass module cable from the OUTPUT connector on the A1 to a B1 bass module. If desired, connect a second B1 to the first B1.

4.Plug one end of the AC power cord into the A1 amplifier and plug the other end into an AC (mains) outlet.

5.Switch the A1 power switch to ON (I).

Figure 10

Connecting the A1 amplifier to the power stand

PackLite® power amplifier

Power stand

Bass - Line Out

CAUTION: DO NOT stack more than four B1 modules in a column.

Additional B1 bass modules

14

Image 22

Contents L1TM Model II System Safety Information Please read this owner’s guideImportant Safety Instructions Information about products that generate electrical noiseSikkerhedsinformation Læs denne brugervejledningSicherheitshinweise Bitte lesen Sie diese Bedienungsanleitung aufmerksam durchInformación DE Seguridad Lea esta guía del usuarioInformations DE Sécurité Veuillez lire cette notice d’utilisationInformazioni Sulla Sicurezza Legga questa guida per l’utenteVeiligheidsinformatie De gebruikershandleiding doorlezenSäkerhetsinformation Läs denna användarhandbokContents Introduction Features and benefitsWelcome Product overview L1 model II system with ToneMatch port Optional equipmentSignal/Clip LED Connections and controlsSystem Setup Parts listPositioning your system Good Better BestSetting up the L1TM model II power stand Assembling the L1 model II Cylindrical Radiator loudspeakerConnecting to AC power Connecting the B1 bass module Bass Module OutAdding a T1 ToneMatchTM audio engine optional Mounting the T1Adding a second B1 bass module optional Adding a PackLite power amplifier model A1 optional User scenarios Setting the analog input levelOperating Information Single musicianMultiple musicians Full band DJ events Cleaning Care and MaintenanceTroubleshooting Getting serviceBass Line Out Electrical MechanicalAudio Input/Output Page