Svenska | Nederlands | Italiano | FrançaisSvenska | NederlandsEspañol | FrançaisDeutschItliano | DeutEspañolchDank | EnglishDansk |
SYSTEM SETUP
Adding a T1 ToneMatchTM audio engine (optional)
The T1 ToneMatchTM audio engine provides additional input/output capabilities to your system, plus digital signal processing to customize the way you sound. The audio engine comes with hardware for mounting it on the left or right side of the L1TM model II Cylindrical Radiator® loudspeaker.
Note: The audio engine mounts on the bottom section of the loudspeaker and requires removal of the top section before starting this procedure.
1.Slide the carriage into the channel on the rear of the L1 bottom and turn the knob clockwise to lock it in place (Figure 8).
2.Insert the mounting bar into the slot in the carriage and push it downward.
3.Place the T1 on the mounting bar as shown.
4.Plug one end of the ToneMatch cable (supplied with the audio engine) into the ToneMatch output port ( 
) on the T1.
5.Using the hook and loop strap, secure the cable to the carriage.
6.Plug the other end of the cable into the ToneMatch port on the power stand.
Figure 8
Mounting the T1
| T1 ToneMatch | |
T1 ToneMatch | audio engine | |
audio engine |
| |
| 4 | |
3 | Hook and loop strap | |
| ||
| 5 | |
Mounting bar |
| |
2 |
| |
| ToneMatch cable | |
Carriage | (supplied with T1) | |
L1 model II | ||
Locking knob | ||
Cylindrical | ||
| Radiator® | |
1 | bottom | |
L1 model II Cylindrical |
| |
Radiator® loudspeaker bottom | 6 | |
| ||
| Power stand |
12