Hotpoint S220E manual Installation, Electrical Requirements, Electrical Connections

Page 23
Installation

Installation

Electrical Requirements

For your own safety, we recommend that your cooker is installed by a competent person such as one who is registered with NICEIC (National Inspection Council for Electrical Installation Contracting). The cooker should be installed in accordance with the latest edition of the IEE Regulations.

Warning: This appliance must be earthed.

Electrical Connections

The installer must check that the voltage shown at the rating plate corresponds with the house electricity supply.

The cooker must be supplied via a suitable double pole isolating switch, having a contact separation of at least 3mm in all poles placed in a readily accessible position adjacent to the cooker.

If the cooker is to be wired into a connector unit, this may be positioned behind the cooker providing the following requirements are met:

i)The connector unit must not project from the wall more than 25mm.

ii)The top of the connector must not be more than 130mm above floor level.

Remove the terminal cover at the rear base of the cooker. Pass the cable through the cable clamp and connect to the appropriate terminals provided.

Allow sufficient cable for any future servicing.

Tighten the screws on the cable clamp and replace the cover.

Make main connections in the connector unit or cooker control unit.

This appliance conforms to B.S. EN 55014 regarding suppression of Radio and Television reception interference.

Adouble Pole control switch having a minimum rating of 32 amps should be used to feed the cooker using a suitably rated cable.

Where a hob is fitted adjacent to or over the cooker, a 45 amp Double Pole control switch should be used to feed both units via separate suitably rated cables.

We recommend a minimum of 4mm2 PVC insulated twin and earth cable conforming to B.S. 6004 for connection of each appliance.

Where a hob is fitted above the cooker the cable connecting the hob to the cooker control unit must be of 2.5mm2 85˚C heat resistant cable to BS6141 table 15

In all cases adhere to routing details (see fig. 5).

This appliance must not be installed over any other appliance that generates heat such as a plinth heater

Note: Due to many different types of installation, a mains cable is not supplied with this

product. The installer will fit the correct type and length of cable.

22

Image 23
Contents S220E Instructionsretain them for future reference ContentsDisposal of your product IntroductionIN THE EVENT OF A CHIP PAN OR ANY OTHER PAN FIRE Safety InformationAlways SAFETY ADVICESafety Information Never GRILL CONTROL FeaturesSTAY CLEAN LINER GRILL ELEMENT GRILL DOOR OVEN LIGHT STAY CLEAN LINERControl Markings Controls0.00 SYMBOLSSETTING THE TIME OF DAY Clock/Minute Minder OperationAny period up to 99 minutes and 50 seconds SETTING THE MINUTE MINDER0.00 Clock/Minute Minder OperationStep Grill Pan and HandleSHELF POSITIONING FOR GRILLING StepAfter use, turn control A Operation when using the GrillSHELF POSITIONING FOR GRILLING StepFood SettingGuide to Grilling FAN OVEN OPERATION Using the Oven for Fan CookingOVEN SHELF POSITIONING FOR FAN OVEN OVEN UTENSILSsetting, the main oven light only will illuminate Using the Oven for other FunctionsFan Only Setting Light Only SettingOperation Using the Oven for other Functions“SLOW” Setting Advantages of “SLOW” cooking areTop Convection Oven Temperature Conversion ChartGas Mark Main Conventional OvenMain Fan Oven Cooking Oven Temperature Chart - MeatIF USING ALUMINIUM FOIL FoodMain Fan Oven Cooking Oven Temperature Chart - BakingBaking Uneven cooking front to back Cooking Result Not Satisfactory?GRILL BAKINGa How Stay clean works Care and Cleaning1. “STAY CLEAN” OVEN LINERS Main Oven 2. CLEANING GRILL AND MAIN OVEN3. OVEN DOORS Care and Cleaning4. REPLACEMENT OF THE OVEN LAMP 5. HOW TO CLEAN THE LAMP LENSFig. Fig. Fig Care and CleaningWarning This appliance must be earthed InstallationElectrical Requirements Electrical Connections1. General Installation2.Final Installation 565mm Installation890mm Max 870mm Min 597mm min 720mm min 565mm 150mm Min 170mm MaxTop View InstallationCheck Something Wrong?Problem Key Contacts After Sales ServiceRepair Service and Information Help Desk Genuine Parts and Accessories