Hotpoint RGB524PR warranty To setthe clock, ‘Fosetthe Timer, To Displaythe Time Day wMIe the Timer

Foliow directions below if your range has the clock and timer shown above.

The electronic range clock and timer allow you to set the timer up to 9 hoursand45 minutes.You havethechoiceof havingthe timer showthe timecountingdownor the timeof day.In eithercase,the timerwillsignalat theend of the timerperiodto alertyou thatthe timeis up.

To setthe clock

NOTE: When you first plug in the range or after a power failure, the entire Clock/Timer display will light up. After several seconds “12:00” will then

flash on the display.

1.Press the CLOCK pad. “12:00” stopsflashingand “SET TIME” flasheson the display.

2.Pressand hold the UP or DOWNpad and the timeof day willchange10 minutesat a time. To changethe time by single minutes,givethe pads shorttaps.

For exa]]lple,to set the clock for 3:15,press and hold the UP pad until “3:10” appears,and then tap the UPpad until “3:15” is displayed.

3.Press the CLOCKpad and the clock will be set. If you do not press the CLOCK pad, the clock will automatically be set within One miilute.

Lc;

1(	-:,
d“					——.
_-.	-..	—	.	——

‘Fosetthe Timer

1.Press the TIMER ON/OFF pad. “:00” appears on the display and “SET TIMER” flashes.

2.Use the UP and DOWN pads to set the timer. Short taps on the UP or DOWN pad change the timer’s setting one minute at a time.

Pressing and continuingto hold the UP pad increasesthe setting five minutes at a time until one hour (“1 :00”) is displayed. After one hour is displayed, pressing and holding the UP pad increases the setting 15 minutes at a time. (Short taps on the UP and DOWN pads will always change the setting by 1-minuteincrements.) The timer can be set for a maximum of 9 hours and 45 minutes.

3.To start the timer, press the TIMER ON/OFF pad. If the TIMER ON/OFP pad is

not pressed, the timer will automatically start after a few seconds.

As the timer counts down, a single beep will indicate when one minute is left. After this beep, the display will count down in seconds. When the timer reaches “:00,” you will hear three sets of three short beeps, and then a single beep every 10 seconds for 10 minutes or until you press any

of the Clock/Timer pads.

When the timer is counting down, use the UP and DOWN pad to change the remaining time, or press the TIMER ON/OFF pad to cancel the timer function. The timer function cannot be cancelled until “SET TIMER” stops flashing and “TIMER” appears on the display.

To Displaythe Time of

Day wMIe the Timer

Is operating

Pressing the CLOCK pad while the timer is operating will not interfere with the timer’s operation; the display will change to show the time of day, but the timer will continue to count down and will still signal when time is up. Simply

pressfie TIMERON/OF~pad

j---.,

(...,

,.,-

(“ ‘~ \l

x=..‘-’”

— . . ..-. -- ... . ..—---.,— -.... - -.