Using continuous flow processing, For Slicing

Using your Sunbeam Oskar 400 (cont).

8.When processing is complete, turn the cover to the right (clockwise), this will stop the food processor (5).

(5)

9.Remove the processing blade from the bowl before removing the processed food.

Note: The stainless steel processing blade is only for use in the processing bowl, for in-bowl chopping, mixing or pureeing functions; NEVER in the continuous flow attachment.

Using continuous flow processing

1.Set up the motor base facing you on a dry, level surface.

Note: The tallest side of the motor housing to the rear.

2.Place the processing bowl over the drive shaft and rotate the container until it drops down evenly onto the base. Turn the processing bowl anti-clockwise firmly until it ‘locks’ into place (1).

3.Place the ejector disc into the processing bowl by holding the shorter stem and placing the disc onto the drive shaft (6).

Ejector

disc Drive shaft

(6)

For Slicing:

4a.Hold the slicing/shredding disc with the raised slicing blade facing upwards. Place the slicing/shredding disc onto the drive shaft, sitting over the ejector disc (7).

Slicing blade

(7)

For Shredding:

4b. Hold the slicing/shredding disc with the series of raised small notches facing upwards. Place the slicing/shredding disc onto the drive shaft, sitting over the ejector disc (8).

Shredding blade

(8)