Sunbeam’s Safety Precautions

SAFETY PRECAUTIONS FOR YOUR

STAINLESS DEEP FRYER.

•Before use always ensure that the internal tank is positioned correctly in the fryer body. ie the max/min level should be on the left of the fryer.

•Never connect the fryer to the electricity supply without placing oil in the tank first.

•If using solid fat, remove the lid and the basket, cut the fat into pieces and place them directly into the tank. Do not melt solid fat in the frying basket as it may damage the appliance.

•Never operate the fryer with oil level below the minimum mark or above the maximum mark.

•Do not touch any metal surfaces of the product while it is in use as they will be hot.

Sunbeam are very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance:

•Read carefully and save all the instructions provided with an appliance.

•Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug - do not pull on the cord.

•Turn the power off and remove the plug when the appliance is not in use and before cleaning.

•Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person.

•Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance.

•Close supervision is necessary when your appliance is being used near children or infirm persons.

•Never leave an appliance unattended while in use.

•Young children should be supervised to ensure that they do not play with the appliance.

•Do not use an appliance for any purpose other than its intended use.

•Do not place an appliance on or near a hot gas flame, electric element or on a heated oven. Do not place on top of any other appliance.

•Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface.

•For safety reasons and to avoid maintenance by unskilled persons, some appliances are ‘sealed’ using tamperproof screws. Such appliances should always be returned to the nearest Sunbeam Appointed Service Centre for adjustment or repair if required.

•Do not operate any electrical appliance with a damaged cord or after the appliance has been dropped or damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair or adjustment.

•For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances.

•Do not immerse the appliance in water or any other liquid unless recommended.

If you have any concerns regarding the performance and use of your appliance, please visit www. sunbeam.com.au or contact the Sunbeam Consumer Service Line.

Ensure the above safety precautions are understood.