Tuner Operations, Tuning to radio stations

Tuner Operations

IMPORTANT!

Make sure the FM and AM antennas are connected.

1 Press TUNER to enter tuner mode. To select another waveband (FM or AM), press TUNER again.

2 Press and hold à or á until the frequency indication starts to change, then release.

➜The system automatically tunes to the next strong signal radio reception.

➜ lights up for FM stereo reception.

For tuning to a weak signal station,

●Press à or á briefly and repeatedly until an optimal reception is found.

You can store up to 40 preset radio stations in the memory, starting from FM and followed by AM bands.

Notes:

–The system will exit presetting mode if no button is pressed within 20 seconds.

–If no stereo frequency is detected during Plug and Play,“CHECK ANTENNA” is displayed.

Using the plug and play (page 3 - P3)

➜Once completed, the last tuned radio station will be played.

You can start the automatic presetting from a selected preset number.

1In tuner mode, press í or ë to select a preset number.

2 Press and hold PROGRAM (PROG) until ÒAUTOÓ is displayed.

➜If a radio station has been stored in one of the presets, it will not be stored again under another preset number.

➜If no preset number is selected, automatic preset will begin from preset (1) and all your former presets will be overridden.

You can choose to store only the favorite radio stations.

1 Tune to your desired radio station (refer to ÒTuning to radio stationsÓ).

➜The preset number starts flashing. If you want

to store the radio station in another preset number, press í or ë.

3 Press PROGRAM (PROG) again to store.

●Repeat steps 1–3to store other radio stations.

E n g l i s h

Plug and Play allows you to store all available radio stations automatically.

1Connect the system to the power supply, ÒAUTO INSTALL - PRESS PLAYÓ is displayed.

In Eco Power standby/standby mode, press and hold ÉÅon the main unit until ÒAUTO INSTALL - PRESS PLAYÓ is displayed.

2 Press ÉÅon the main unit to start installation.

➜ÒINSTALL TUNERÓ is displayed.

➜All previously stored radio stations will be replaced.

➜Once completed, the last tuned radio station will be played.

●In the tuner mode, press í or ë.

➜ The preset number, radio frequency, and waveband are displayed.

●Press and hold Ç until ÒPRESET DELETEDÓ is displayed.

➜The current preset radio station will be deleted.

➜All other preset radio stations with higher numbers are decreased by one.