Installation, Risk of Personal Injury, Setup

INSTALLATION

NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation.

Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual.

WARNING:

RISK OF PERSONAL INJURY

Installation procedures must be performed by a qualified technician with full knowledge of all applicable electrical and plumbing codes. Failure can result in personal injury and property damage.

CAUTION:

RISK OF

DAMAGE

DO NOT connect or energize this appliance until all in- stallation instructions are read and followed. Damage to the appliance will result if these instructions are not followed.

CAUTION:

ELECTRICAL

SHOCK HAZARD

The ground screw of this appliance must be connected to a suitable building ground.

IMPORTANT:

Contact a licensed electrician to install and connect electrical power to the appliance.

IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty.

UNPACKING & INSPECTION

Carefully remove the appliance from the carton. Remove all protective plastic film, packing materials and accessories from the Appliance before connecting electrical power or otherwise performing any installation procedure.

Carefully read all instructions in this manual and the Installation Instruction Sheet packed with the appliance before starting any installation.

Read and understand all labels and diagrams attached to the appliance.

Carefully account for all components and accessories before discarding packing materials. Store all accessories in a convenient place for later use.

SETUP

Refer to the Installation Instruction Sheet for cutout dimensions and required clearances. Maintain required clearances between the appliance and adjacent surfaces.

Unit must be installed such that it can be serviced from the bottom.

If the area beneath is to be used storage, a baffle must be placed 8" beneath the hotplate to prevent contact with elevated temperatures.

Provided gaskets for hotplate, hotplate adapter ring and control panel must be used in this installation. Damage caused by failure to use these gaskets is not covered by warranty.

ELECTRICAL INSTALLATION

Fig. 2 H-006UL Wiring Diagram

Electrical flex-conduit is provided to allow the hotplate to be located up to 32" from the control panel. Excess conduit must be coiled and secured to prevent damage. DO NOT cut the conduit or wiring.

Unauthorized alteration of the conduit or wiring voids the warranty and UL listing.

Connect field wiring to provided pigtail with wire nuts (not provided).