Extron electronic 7200, 3200 manual Removing and Installing a Fan Module, Removing a Fan Module

Removing and Installing a Fan Module

The FOX Matrix 3200 has one replaceable fan module; the FOX Matrix 7200 has two identical fan modules. If a fan fails, it should be replaced at the earliest opportunity.

NOTE The fan modules are hot-swappable; they can be removed or installed without powering down the switcher.

Removing a Fan Module

1.Rotate the top and bottom knurled knobs to completely loosen the captive screws (see figure 67).

REMOTE RS-232/RS-422	RESETTRI-LEVELBI-LEVELSWITCH
LAN ACTLINK	REFERENCE

IN

OUT

		A
		IN
	OUT
		A
		IN
	OUT
		A
		IN
	OUT
		A		.
			1.2A	MAX
100				REDUNDANT
		50/60Hz
	-240V
BOTHDISCONNECTPOWER BEFORECORDSSERVICING		50/60Hz		PRIMARY
				.
			1.2A	MAX
100-240V

IN OUT

B IN OUT

B IN OUT

B IN OUT

B

OUT

OUT

OUT

OUT

	IN
	OUT
IN	D
	IN
OUT
	OUT
C	D
IN
	IN
OUT
	OUT
C	D
IN
	IN
OUT
	OUT
C	D
IN
OUT
C	POWER

IN OUT

E IN OUT

E IN OUT

E IN OUT

E

IN OUT

F IN OUT

F IN OUT

F IN OUT

F

IN OUT

G IN OUT

G IN OUT

G IN OUT

G

IN OUT

H IN OUT

H IN OUT

H IN OUT

H

Align with Plastic Guides

	1-8
	CA
ANAHEIM,	9-16
	17-24
	25-32

Figure 67. Fan Replacement

2.Gently pull on the screws to loosen the fan from the backplane.

3.Slide the fan out of the chassis.

Knurled Knobs

Installing a Fan Module

1.Orient the fan to be installed so that the printing on the back of the panel is right-side up.

2.Align the flanges on the fan with the top and bottom fan guides (see figure 67).

3.Gently slide the fan into the enclosure until the fan meets resistance.

4.Gently seat the fan in the backplane.

5.Use a screwdriver to tighten the top and bottom knurled knobs/captive screws to secure the fan in place.

FOX Matrix 3200 and 7200 Switchers • Maintenance and Modifications 114