Extron electronic 7200, 3200 manual Reset Button and LED, RJ-45 connector wiring

The cable used depends on your network speed. The switcher supports both

10 Mbps (10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet), half-duplex and full-duplex Ethernet connections.

•10Base-T Ethernet requires CAT 3 UTP or STP cable at minimum.

•100Base-T Fast Ethernet requires CAT 5e UTP or STP cable at minimum.

RJ-45 connector wiring

The Ethernet cable can be terminated as a straight-through cable or a crossover cable and must be properly terminated for your application (see figure 10).

•Crossover cable — Direct connection between the computer and the FOX matrix switcher

•Patch (straight) cable — Connection of the FOX matrix switcher to an Ethernet LAN

Pins:

12345678

Insert Twisted

Pair Wires

RJ-45

Connector

Crossover Cable

	End 1	End 2
Pin	Wire color	Wire color
1	White-green	White-orange
2	Green	Orange
3	White-orange	White-green
4	Blue	Blue
5	White-blue	White-blue
6	Orange	Green
7	White-brown	White-brown
8	Brown	Brown
	T568A	T568B

A cable that is wired as T568A at one end and T568B at the other (Tx and Rx pairs reversed) is a "crossover" cable.

Straight-through Cable

Pin	End 1	End 2
	Wire color	Wire color
1	White-orange	White-orange
2	Orange	Orange
3	White-green	White-green
4	Blue	Blue
5	White-blue	White-blue
6	Green	Green
7	White-brown	White-brown
8	Brown	Brown
	T568B	T568B

A cable that is wired the same at both ends is called a "straight-through" cable, because no pin/pair assignments are swapped.

Figure 10. RJ-45 Connector and Pinout Tables

Reset Button and LED

E Reset button (see figure 3 on page 8 and figure 4 on page 9) —
The recessed Reset button initiates four levels of matrix switcher reset. For four	RESET

different reset levels, press and hold the button while the switcher is running or while you power up the switcher (see Reset Operations on page 43 for details).

•Events (mode 3) reset — Toggles events monitoring on and off.

•IP settings (mode 4) reset — Reset the IP functions of the switcher.

NOTE: The IP settings reset does not replace any user-installed firmware.

•Absolute (mode 5) reset — Restore the switcher to the default factory conditions.

•Hard reset — Restore the switcher to the default factory conditions and return the switcher to the default firmware that shipped with the unit.

NOTES:

•Factory loaded firmware is active until it is replaced or the power is cycled.

•Hard reset does not clear the current configuration.

FOX Matrix 3200 and 7200 Switchers • Installation 14