Extron electronic 7200, 3200 manual Troubleshooting, Performing a Hard Reset Reset

Performing a Hard Reset (Reset 1)

The hard reset function restores the switcher to the base firmware that it was shipped with. After a hard reset, events do not automatically start, but user settings and files are restored.

Perform a hard reset as follows:

NOTE: The hard reset restores the factory-installed firmware. The switcher reverts to that factory firmware the next time power is cycled off and on unless a firmware update is performed before the power cycle.

1.If necessary, turn off power to the switcher.

2.Press and hold the Reset button on the rear panel while you apply AC power to the switcher (see figure 27).

Press and hold the Reset button while you apply power to the switcher.

57-64 49-56 41-48

LIN
TX	1
LINK
TX	1
LINK

2 A

2 A

RX LINK

RX LINK

TK

LIN

TX

LINK

1

B

2 B

RX LINK

TX LINK

1	C	LY
		SUPP
		POWER
PRIMARY

RESET

The switcher flashes the button indicators light amber, off, green, red, and amber and then turns them off.

Continue to hold the Reset button until all input and output buttons are either unlit or return to background illumination.

Release the Reset button.

CA

ANAHEIM,

Power

RESET

Figure 27. Hard Reset

Troubleshooting

This section recommends what to do if you have problems operating the switcher.

1.Ensure that all devices are plugged in and powered on.

2.Check to see if one or more outputs are muted.

3.Ensure an active input is selected for output on the switcher.

4.Ensure that the proper signal format is supplied.

5.Check the cabling and make corrections as necessary.

6.Call the Extron S3 Sales and Technical Support Hotline if necessary. See the end of this guide for the phone number in your region of the world.

FOX Matrix 3200 and 7200 Switchers • Operation 46