Extron electronic 7200, 3200 manual X6$ =

X6$ =		Port timeout (10-sec. increments) 1 (= 10 seconds) – 65000 (default is 30 = 300 seconds = 5 minutes)
X6%	=	SMNP port number	00000 (= disable) – nnnnn. Default = 00161. Leading zeroes are not necessary for entry.
X6^ = SNMP contact name and location Up to				64 alphanumeric characters. Default = Not•Specified.
X6& = SNMP community name			Up to	64 alphanumeric characters.
			Default = public (for read community) or private (for read-write community).
X6*	=	Trap target	1 – 3
X6( =		SNMP trap version	2 or 3, or 0 = empty (default) if no target set
X7)	= SNMP target 1 through 3		70 – 72. 70 = SNMP target 1, ... 72 = target 3

Command and Response Table for IP- and SNMP-Specific SIS			Commands
Command Function	SIS Command	Response	Additional description
	(Host to Unit)	(Unit to Host)

IP setup commands

Set matrix name

Read matrix name (location)

Reset matrix name to factory default

Set time and date

Read time and date

Set GMT offset

Example: Read GMT offset

Set Daylight Saving Time Read Daylight Savings Time Set IP address

Read IP address

Read hardware address Read # of open connections Set subnet mask

Read subnet mask

Set gateway IP address Read gateway IP address Set administrator password Read administrator password

Reset (clear) administrator password

Set user password Read user password Reset (clear) user password Set mail server, domainname Read mail server, domainname Set e-mail recipient

EX4)CN}	Ipn•X4)]
ECN}	X4)]
E•CN}	Ipn•X4)]
EX4@CT}	IptX4@]
ECT}	X4#]
EX4$CZ}	IpzX4$]
E8.3CZ}	Ipz+08:30]
ECZ}	X4$]
EX4%CX}	X4%]
ECX}	X4%]
EX4^CI}	IpiX4^]
ECI}	X4^]
ECH}	X4&]
ECC}	X4*]
EX4^CS}	IpsX4^]
ECS}	X4^]
EX4^CG}	IpgX4^]
ECG}	X4^]
EX4(CA}	Ipa•X4(]
ECA}	X4(]
E•CA}	Ipa•]
EX4(CU}	Ipu•X4(]
ECU}	X4(]
E•CU}	Ipu•]
EX4^,X5),X4(CM}	IpmX4^,X5),X4(]
ECM}	X4^,X5),X4(]
EX5!,X5@CR}	IprX5!,X5@,]

“FOX-Matrix-3(7)-”plus the last 3 pairs of the MAC address.

In the command, the divider between hours and minutes can be either a colon or a period. In the response, the divider is a colon.

8.3 = 8:30

Reads MAC address.

This command sets the e-mail recipient. To receive e-mail notifications, you must then set the events that the switcher reports, using one or more separate Set e-mail(EM) SIS commands (on the next page).

Example:

Read e-mail recipient

E69,Jsmith@folklore.netCR} Ipr69,Jsmith@folklore.net,]

EX5!CR}X5@,]

FOX Matrix 3200 and 7200 Switchers • Programming Guide 68