Making Drinks with Milk

	coffee buttons (		or	).
t	"U UIF FOE PG EFMJWFSZ UP JODSFBTF UIF RVBOUJUZ PG DPòFF
	in the cup, just press (within 3 seconds) one of the coffee
	buttons (	or		).
Once the coffee		has been	made, the appliance is ready to use
again.

Please note!

t 7BSJPVT BMBSN NFTTBHFT DPVME CF EJTQMBZFE XIJMF VTJOH the machine (fill tank, empty grounds container, etc.). Their meaning is explained in the section “Displayed messages”(page 20).

t 'PSIPUUFSDPòFFTFFUIFTFDUJPOi5JQTGPSBIPUUFSDPòFFw (page 12).

t *GUIFDPòFFJTEFMJWFSFEBESPQBUBUJNFUPPXFBLBOE not creamy enough or too cold, read the tips in the “Troubleshooting”section on page 21.

Making coffee using pre-ground coffee

		Important!
t	/FWFSBEEQSFHSPVOEDPòFFXIFOUIFNBDIJOFJTPòPSJU
	could spread through the inside of the machine and dirty
	it.
	This could damage the appliance.
t	/FWFSVTFNPSFUIBOMFWFMNFBTVSFPSJUDPVMEEJSUZUIF
	inside of the coffee		maker or block the funnel.
		Please note!


	If you use pre-ground coffee, you can only make one cup
	of coffee at a time.
1.	Press the		button (fig. 9) until “Pre-ground” is
	displayed.

2.Open the beans container lid; then open the pre-ground coffee funnel lid by pushing on PUSH and, once released, open the lid.

3.Make sure the funnel is not blocked, then add one level measure of pre-ground coffee (fig. 17).

4.Place a cup under the coffee spouts.

5.Press the 1 cup coffee button (fig. 11).

6.Preparation begins. The amount of coffee selected is displayed together with a progress bar which gradually fills as preparation progresses.

Please note!

If“Energy saving”mode is enabled, you may have to wait a few seconds before the first coffee is delivered.

Please note!

t 5PBWPJEQSPEVDJOHNJMLXJUIQPPSGSPUIPSMBSHFCVCCMFT always clean the milk container lid and hot water nozzle as described in the section “Cleaning the milk container” on pages 14 and 17.

Filling and attaching the milk container

1. Remove the lid (fig. 18);

'JMMUIFNJMLDPOUBJOFSXJUIBTVóDJFOURVBOUJUZPGNJML not exceeding the MAX level marked on the container (fig. 19). Each mark on the side of the container corresponds to 100 ml of milk.

Please note!

t 'PSBEFOTFSNPSFFWFOGSPUIZPVTIPVMEVTFTLJNNFE or partially skimmed milk at refrigerator temperature (about 5°C).

t *Gi&OFSHZ4BWJOHwNPEFJTFOBCMFEZPVNBZIBWFUPXBJU a few seconds before the first drink is delivered.

3.Make sure the milk intake tube is correctly inserted in the bottom of the milk container lid (fig. 20).

4.Place the lid back on the milk container.

5.Remove the hot water spout from the nozzle.

6.Attach the container to the nozzle and push as far as it will go (fig. 21). The machine emits a beep (if the beep function is enabled).

1MBDFBTVóDJFOUMZMBSHFDVQVOEFSUIFDPòFFBOEGSPUIFE milk spouts. Adjust the length of the milk spout. To move it nearer the cup, simply pull it downwards (fig. 22).

8. Follow the instructions below for each function.

Adjusting the amount of froth

Turn the froth adjustment dial on the milk container lid to adjust the amount of froth on the milk delivered while making drinks with milk.

Dial	Description	Recommended for…
position

	No froth	FLAT WHITE/
		HOT MILK

	Min. froth	LATTE

	Max. froth	CAPPUCCINO

coffee buttons (

Making coffee using pre-ground coffee

displayed.