ELECTRONIC CLOCK (fig. 16)
The programmer is equipped with an elec- tronic clock with illuminated numbers which indicates hours and minutes.
Upon immediate connection of the oven or after a power cut, three zeros will flash on the programmer display.
To set the correct time of day it is necessa-
ry to push the 
button and then the 
or 
button until you have set the correct time (fig. 16).
In another way push simultaneously the
two buttons and at the same time push the 
or 
button.
Note: If the clock is reset it deletes any pre- viously set programs
NORMAL COOKING WITHOUT THE USE OF THE PROGRAMMER
To manually use the oven, without the aid of the programmer, it is necessary to can- cel the flashing AUTO by pushing the 
button (AUTO will be switched off and the
symbol 
will illuminate - Fig. 17). Attention: If the AUTO is illuminated (which means a cooking program has already been inserted), by pushing the button 
you cancel the program and return to ma- nual operation.
If the oven is switched on, you must switch off manually.
Figure 17
ELECTRONIC TIMER
The timer program consists only of a buz- zer which may be set for a maximum period of 23 hours and 59 minutes.
If the AUTO symbol is flashing push the
button.
To set the time, push the 
button and the 
or until you obtain the desired time in
the display (fig. 18).
Having finished the setting, the clock hour
will appear on the panel and the symbol will be illuminated.
The countdown will start immediately and may be seen at any moment on the panel
by simply pressing the button 
.
At the end of the time, the 
symbol will disappear and the buzzer will sound and continue for approximatley 7 minutes or until a button is pressed (not the 
/ 
buttons). After a short time the display will revert back to the time of day.
SETTING THE FREQUENCY OF THE AUDIBLE SIGNAL
The buzzer has 3 different tones and can be changed by pressing the 
button, but only when the time of day is displayed
Figure 18
23