FEDERAL COMUNICATIONS COMMISSION (FCC) REGULATORY INFORMATION
Federal Communications Commission
Part 15 compliance —
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by removing and applying power to the equipment, the user is encouraged to try to correct the interference by one or more of the following measures:
∙Reorient or relocate the receiving satellite dish antenna.
∙Increase the separation between the equipment and the digital satellite receiver.
∙Connect the equipment into an outlet on a circuit different from that to which the digital satellite receiver is connected.
∙Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify and Resolve Radio and TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington, DC.
To meet FCC requirements, only peripherals (computer input/output devices, terminals, printers, etc.) certified to comply with the Class B limits may be attached to this device. Operation with
To meet FCC requirements, shielded cables are required to connect the device to a personal computer, peripheral, or other Class B certified device.
Part 68 compliance —
1.The FCC has established Part 68 of the FCC Rules, which permit this device to be directly connected to the telephone network. Standardized jacks are used for these connections. This equipment should not be used on coin lines or party lines.
2.If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until repair has been made. If this is
not done, the telephone company may temporarily disconnect service.
3.The telephone company may make changes in its technical operations and procedures; if such changes affect the compatibility or use of this device, the telephone company is required to give adequate notice of the changes. You will be advised of your right to file a complaint with the FCC.
4.If the telephone company requests information on what equipment is connected to their lines, inform them of:
∙the telephone number this unit is connected to.
∙the ringer equivalence number (REN). The number can be found on a label located on the bottom of the equipment.
∙the Universal Service Order Code (USOC) jack required. This equipment requires a USOC RJ11 jack.
∙the FCC registration number. The number can be found on a label located on the bottom of this equipment.
D