Silvercrest SWKD 3000 A16 manual Keeping water hot, Risk of personal injury, Warm w

Note

Do not let the water stand in the kettle for longer than is absolutely necessary. That would lead to scale deposits. Pour away the water that is no lon- ger required immediately.

Keeping water hot

With this kettle you can maintain the water at a temperature of (about) 40°C, 60°C, 80°C or 100°C for 30 minutes. Should you have set the desired temperature maintenance at 100°C, to avoid excessive steam development the kettle holds the water at a temperature of between about 90°C and 100°C. If the desired heating maintenance temperature is 80°C, 60°C or 40°C, the water he- ater holds the water at a temperature of between about 8°C above or below the selected temperatu- re.

￿Important

Use the keep-warm function only when there is at least 0.5 liters of water in the kettle. If there is less water in it, the kettle may be switched off within the 30 minutes in order to protect the heating element.

￿Warning

BEFORE you lift the kettle from the base y, first disconnect the plug from the mains power socket. This prevents causing a short circuit by water possibly spil- ling out of the kettle and falling onto the live electrical connections in the base y.

￿Risk of personal injury

For safety reasons, the lid should not be opened while the water is boiling or is very hot. There is a risk of receiving severe scalds.

The keep-warm setting can be made before, during or immediately after the boiling process:

Before the boiling process

•Before the boiling process, press the KEEP WARM w button.

•Press the button SET TEMP r repeatedly until the LED q at the desired temperature glows.

•Press the button Start to begin the boiling and then the keep-warm process.

The LED q of the currently set temperature glows, the LED integrated in the KEEP WARM w button glows as well as the LED in the On/Off e button. The water will now also be kept warm after being heated.

During the boiling process

•Start the boiling process as described in the section "Heating water".

•During the boiling process, press the KEEP

WARM w button.

On completion of the boiling process the LED q of the currently set temperature glows, the LED integra- ted in the KEEP WARM w button glows as well as the LED in the On/Off e button.

The water will now also be kept warm after being heated.

After the boiling process

•After the signal tone, indicating the end of the boiling process, press the button KEEP

WARM w.

The appliance will then automatically maintain the keep-warm temperature at the temperature you selected to heat the water. The LED q of the cur- rently set temperature glows, the LED integrated in the KEEP WARM w button glows as well as the LED in the On/Off e button. The water will now be kept warm.

- 5 -