Oster XVGA manual Housing or Back Case, Door or Hopper, Pusher Plate, Plate Holder with Shaft

Page 1

INSTRUCTIONS FOR OPERATION AND CARE

XVGA GRATER/SHREDDER AND

XVSA SLICER ATTACHMENTS

Our versatile grater/shredder attachments can be used to grate and shred cheeses, raw vegetables, nuts, breadcrumbs, etc. depending on the plate selected. Our S/S plates are available with 3/32", 3/16", 1/4", 5/16" or 1/2" size holes and a special grating plate for breadcrumbs & hard cheeses. A plate holder with shaft and one 3/16" plate are included with the XVGA attachment.

XVGA XVSA

Our slicer attachments can be used for slicing potatoes (from 1/16" to 5/8" thickness); cut- ting vegetables for salads and coleslaw; or for slicing fruits and nuts.

An adjustable slicer plate with shaft are included with the XVSA attachment.

WARNING

There are sharp rotating knives behind the front door; keep hands out of hopper and use a feed pusher or stomper to push product into the hopper – do not use your fingers. Always stop power unit before opening front for changing, cleaning, or servicing anything on this unit. Only trained and qualified persons 18 years and older should use these attachments.

These attachments are made up of the following four basic components:

1.XVSH Housing

2.XVSD Front Door or Hopper

3.XVSP Pusher Plate

4.Plate Holder or Adjustable Slicer Plate units

1.Adjustable Slicer Shaft XASP with S/S "S" knife

2.Shredder Plate Holder XPH

XVSH

XVSD

XVSP

XPH

HOUSING OR BACK CASE

The housing or back case mounts into the attachment socket of a mixer, food cutter or power drive unit and is retained by the pointed thumbscrew that goes through the attach- ment hole into the indentation on the neck of the machine.

DOOR OR HOPPER

The front door is a hopper and lever feed design. It hinges onto the back case and is held closed with an adjustable latch. To remove the front door, lift the latch and swing the door open while lifting it from the hinge holes.

PUSHER PLATE

The pusher plate has an integrated handle to push the food into the rotating disc or slicer knife. It has pins at both ends of the top and hinges into the front door. The pusher plate has a rubber-tipped stop screw (XP1018) under the handle that can be adjusted to prevent the plate from coming in contact with the plate or blade.

PLATE HOLDER WITH SHAFT

Shredder plates are available with 3/32", 3/16", 1/4", 5/16" or 1/2" hole sizes. These plates have keyhole slots for attaching to shouldered studs on the plate hubs.

1

Image 1
Contents Door or Hopper Housing or Back CasePusher Plate Plate Holder with ShaftTo Install XPH Plate Holder Assembly To Install Shredder or Grater DiscsAdjustable Slicer Plate Assembly & Installation To Remove Xasp Adjustable Slice Plate Assembly from Housing To Remove Attachment from Power UnitPusher Plate Removal OperationCleaning Maintenance InstructionsPusher Plate Stop Knife SharpeningPart Number Listing Food Limited XVSA/XVGA Attachment Warranty