6.When using the adjustable slicer plate, make sure it is cleaned frequently to assure easy thickness adjustment. Occasionally disassemble the slicer plate for a thorough cleaning. To do this it is necessary to unscrew the knurled thrust bearing, which has a left hand thread, to release the spring. Withdraw the knife and shaft assem- bly. Unscrew the adjusting nut from the plate. Use a drop of approved food machinery oil on the shaft and adjust- ment threads after cleaning.
Adjustment
NutThrust
Bearing
Spring
Note: After cleaning, to prevent damage the thrust bearing must be tightened until sealed against shoulder on shaft. Failure to properly reassemble can result in damage to knives, shaft and slicer plate. Do not clean any of these compo- nents in a dishwasher with strong detergents or chemicals. Use a USDA approved grease on the shaft for best operation.
CAUTION: Do not permit water or moisture to remain on or in the hub, shaft, or the rear opening in the hous- ing. This condition will result in rusting which will eventually destroy the rear end components and shaft and void the factory warranty.
KNIFE SHARPENING
Occasional touching up along the edges of the knife with a honing stone will keep cutting operations at peak performance.
PUSHER PLATE STOP
Frequently check that the pusher plate does not hit the grater plate holder or knife shaft assembly. The Pusher Plate Stop XP1018 can be adjusted to avoid touching the internal moving parts. With proper care and maintenance, your Vegetable Grater/Shredder/Slicer Attachment will provide you with many years of performance.
XPH Plate Holder
XP1030
Plate
XP1012
XVSP
Pusher Plate
XP1026A
XP1026 Brass
XP1007
XP1010 XP1009
XP1035 | XVSD |
|
|
|
|
|
| XP1014 |
|
| XP1036 |
|
| Housing |
| XP1017 |
|
|
|
| XP1018 | XP1013 |
| XP1024 Brass |
|
|
| ||
| XVSD Door |
|
| |
|
|
| XP1023 | |
with Hopper Opening | XP571 | XP1022 Plastic | ||
|
|
| (Knife only) | XP1571 (Knife and Shaft) |
XASP Adjustable Slicer Plate Assembly
XP1011
XP1008
XP1005A
XP1004
XP1005
XVSH Housing
5