Troubleshooting Guide .
The following check will assist in the correction of most problems that you might encounter with your unit. Perform the checks described below before contacting your Blaupunkt dealer.
Symptom | Cause |
| Remedy |
|
|
|
|
No Power | Fuse blown. | Replace with a fuse of the same type | |
and rating as the original. | |||
|
| If the fuse blows again, consult with | |
|
| your dealer. | |
|
|
|
|
| Improper connection. | Check | connections. |
|
|
|
|
No Sound | Improper connection. | Check | connections. |
|
|
|
|
No Sound, | Fader set to | Set fader to center position to | |
| determine if speakers are wired for | ||
|
| front or | rear setting. |
|
|
|
|
Magazine cannot be | Attempt made to insert magazine | Insert it in proper direction. | |
installed. | improperly. |
|
|
|
|
|
|
Selected disc does | Disc is loaded incorrectly. | Load disc with play side facing up. | |
not play. |
| (Printed side should face down). | |
|
|
|
|
| Large scratches on disc or warped | Compare sound with another disc. If | |
| disc. | sound from second disc is | |
Noise is heard |
| acceptable, first disc is defective. | |
|
|
| |
|
|
| |
during playback or | Extemely dirty disc. | Clean disc. | |
sound is |
|
|
|
|
|
| |
intermittent. | Transit Screws still in place. | Remove 3 screws on bottom of unit | |
|
| and try again. | |
|
|
| |
| Set the | ||
| position. | correct position (See page | |
|
|
|
|
|
|
|
|
Wireless Remote Control does not work
Battery is dead. | Replace Battery. |
|
|
Commander ir sensor or Wireless | Clean the sensor and/or the control’s |
Remote Control is dirty. | lens. |
Fuse Replacement
When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit.
Moisture Condensation
On a rainy day or in a very damp area, moisture may condense on the lens inside the unit Should this occur, the unit will not operate properly. In this case, remove the disc and wait for about an hour until the moisture has evaporated.
17