Electrical Connections
Electrical Connections
•Caution: before making connections, disconnect the ground wire terminal of the car battery to avoid shcrt circuits.
•Use this unit only with negative ground 12 Volt (1 l- 16 Volt) direct current (DC).
•Be sure to use the supplied changer cord. Using a cord other than the one supplied may cause noise or damage.
•Be sure to connect the changer cord to the FM Modulator before mounting. If you attach the changer cord to the modulator and the cord projects down toward the back of the modulator, remove the cord and attach the other end of the cord to the modulator.
Power Connections - To prevent short circuits and@ serious damage:
•Disconnect the vehicle battery’s negative terminal before making connections.
Note - If the changer is to be installed in a car that is equipped with an
may be lost. Under these conditions, use extra caution to avoid causing a short circuit during installation.
•Connect leads according to the wiring diagram.
•Connect the yellow lead to a constant source of power which has passed through the vehicle’s fuse unit.
•Connect the red power input lead only after the other leads are connected. And be sure to connect it to a positive (+) 12 Volt power terminal that is energized only when the ignition key is set to the accessory position or on position.
•Connect the black lead to a grounded metal part of the vehicle. We recommend grounding all audio system black ground leads (head unit, external amplifier, etc.) to a common point.
Modulator
output
,
Radio Antenna Input (in back)
-
Yellow | Fuse 5A | To Battery | ||
|
|
|
| |
|
|
| Ip |
|
t0
DIN Connection Cord (6 pin)
Commander 11
FM Radio ’ | (6 pin) | CD Changer |
6