Maytag manual Model numbers ERV-150, HRV-150 ERV-210, HRV-210

Page 11

4.0

TechnicalData

(cont’d)

4.4DIMENSIONS

Model numbers:

•ERV-150

•HRV-150

6" (152mm)

30-1/4" (768mm)			13-3/4" (349mm)

20" (508mm)

VK0040

2.5" (63mm)

Model numbers: 6" (152mm)

30-1/4" (768mm)

19" (483mm)

• ERV-210

• HRV-210

20" (508mm)

VK0039

2.5" (63mm)

4.5CONTROLS AND FURNACE LINK OPTION

Main controls:	Optional control:	Link option:
• Basic Wall Control	• 20/40/60-minute push button	• Furnace interlock (use with
• Electronic Wall Control		forced air systems)

4.6SPECIFICATIONS

Model numbers			ERV-150, HRV-150	ERV-210, HRV-210
Weight			65 lb (30 kg)	73 lb (33 kg)
Port Diameter			6” (152 mm)	6” (152 mm)

Drain Diameter			1/2” (12 mm)	1/2” (12 mm)
Installation		Chains, springs and hooks (provided with the unit).
Motor Speed	High and low speeds factory set (optional increased low speed - BLUE wire).
Electrical supply			120 V, 60 Hz	120 V, 60 Hz
Power Consumption			150 Watts	225 Watts

11

Image 11

Contents Ventilation Systems Installer ManualTable of Contents Nstallation of the C Ontrols About this ManualService To Order Parts Contact your local distributor High speed SizingHRV ERV-210 Technical DataModel Number ERV-150 Model Number HRV-150 Model numbers ERV-150, HRV-150 ERV-210, HRV-210 Fully Ducted System Typical InstallationInspect the Contents of the BOX InstallationCalculating the Duct Size Installation cont’dPlanning of the Ductwork Calculating the Duct Size CONT’D Installing the Ductwork and RegistersInstalling the Ductwork and Registers cont’d Method 2 return-return Method 1 return-supplyDo not use screws to connect rigid ducts to the ports Connecting Ducts to the UnitInsulated flexible duct Rigid duct152 mm Intake Hood 18 457 mm Optional duct Installing the Exterior HoodsConnecting the Drain Exhaust HoodAll models require a main control Control DevicesOptional Control Main and Optional Controls Available for Your Unit Other FeaturesSpecial Cold Weather TBI Mode for Ervs Characteristics of cold weather TBI modeNever install more than one main control per unit Installation of the ControlsDimensions and Specifications Main Controls Installation of the Main ControlInstallation of the Main Control cont’d Electrical Connection to the Furnace Electrical Connection to Optional ControlsDiagram WiringAir Flow Balancing If you are using Flow CollarsIf you are using Flow Measuring Stations Balancing Procedure Main Controls 11.0 Overall VerificationDo not oil the motor. It is already permanently lubricated Maintenance / Instructions for UserStart-up troubleshooting TroubleshootingLight does not stay on References Warranty