4.With cabinet doors open, place line selected on mounting template even with the bottom front edge of your cabinet, and tape in place against the lip (H).
H
5.With the paper securely taped in place against the lip, fold the rest of the mounting template back against the underside of cabinet surface, bending it to remain flush against both the back of the lip and the underside of the cabinet (J).
J
Important: Do not align screw holes on template with the partition between cabinets, as this will prevent you from installing the appliance properly. Pay close attention to where the drill holes will be set so as not to damage your cabinets during mounting. Drilling through your cabinet’s partition may cause damage to cabinets and prevent proper installation.
6.Drilling from under the cabinet up, drill holes through the 4 places marked on the template using a
Important: Always ensure you are drilling straight up through the marked mounting hole on the template. Drilling at an angle may prevent proper installation and may damage cabinets if the drill bit pierces the partition.
7.Once holes are drilled, remove tape and mounting template and save template with your instructions in case you move or wish to remount at a later time.
8.Wipe dust and debris off inside cabinet surface. Also, make sure under side of cabinet is clean.
9.Place a washer inside the cabinet over each of the 4 holes you drilled.
10.Now, use your ruler or the paper ruler provided to measure the overhang height, placing your ruler vertically against the underside of the cabinet behind the overhang. This number determines the number of spacers you need, using a number of spacers equal to the overhang height.
For example, a 1” overhang would use 2, ½” spacers on each of the holes (K).
K
11.Place a washer inside the cabinet over each of the 4 holes you drilled.
12.Drop one of your screws through each of the washers covering the holes in the cabinet, from inside the cabinet down.
13.Place the appropriate number of spacers determined in step 9 on each screw to ensure the appliance will be even (L).
Note: If not enough spacers are available, use spacers on rear two screws only. The front edge of cabinet will provide support for the two front screws.
L
Note: For spacer installation, you may require assistance in mounting in order to hold spacers in place while securing the appliance at the same time. If assistance is not available, use a small clamp to hold the spacers in place while you position the appliance.
14.Once spacers are set, hold appliance up and tighten screws to secure. Screw from inside the cabinet down.
Note: Always tighten screws to ensure the appliance does not move or shake during operation.
15.Pull out cord from cord storage behind appliance and plug into standard electrical outlet. Extra cord can be fed back into storage or hung over cord management hook behind unit (see illustration F).
Note: If you are connecting this appliance to the receptacle of another †SpaceMaker appliance such as the toaster oven or coffeemaker, make sure you can easily unplug the appliance following use.
7 | 8 |