Whirlpool GZ5730, GZ5736 Use and Care Information, Operation, Replacing Halogen bulbs

Page 7

Use and Care Information

center flange of cap

19.Remove both light socket caps. Use pliers to grip the center flanges of each cap, twist while pulling down. Discard the caps.

Install (2) PAR20, 50W maximum halogen bulbs or (2) R16, 40W maximum incandescent bulbs.

Bulbs must be purchased separately.

20.Replace filters. Note: Filter slot must be toward front of hood. For non-vented recirculating installations, make sure you have installed the non-vented filters on the back sides of the aluminum mesh filters. (See Step 6.) Make sure fan blade turns freely.

21.Turn power supply on and check for proper operation.

WARNING — To reduce the risk of fire or electrical shock, do not use this fan with any solid-state speed control device.

WARNING — TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock switch power off at service panel and lock service panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device such as a tag to the service panel.

CAUTION: For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.

WARNING — TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

Always turn hood ON when cooking at high heat or when cooking flaming foods.

Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.

Use proper pan size. Always use cookware appropriate for the size of the surface element.

WARNING — TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:

SMOTHER FLAMES with a close- fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.

NEVER PICK UP A FLAMING PAN — You may be burned.

DO NOT USE WATER, including wet dishcloths or towels — a violent steam explosion will result. Use an extinguisher ONLY if:

You know you have a Class ABC extinguisher, and you already know how to operate it.

The fire is small and contained in the area where it is started.

The fire department is being called.

You can fight the fire with your back to an exit.

To get the most efficient use from your new range hood, read the “Use and Care Information” section.

Keep your Whirlpool

Installation Instructions and Use and Care Guide close to range hood for easy reference.

Operation

LOW

HIGH

LOW

HIGH

FAN

 

 

LIGHT

Fan: The 3-position rocker switch (on the left) controls the fan. The left position is low speed, center position is off, and the right position is high speed. An indicator light shows that the fan is on.

Light: The 3-position rocker switch (on the right) controls the lights. The left position is low light intensity, center position is off, and the right position is high light intensity.

Replacing the

Halogen bulbs:

Before you begin, make sure that the range hood is turned off and that the lamps have had sufficient time to cool. Halogen bulbs burn extremely hot. See bulb packaging for further information.

Replace with (2) PAR20, 50W maximum halogen bulbs or (2) R16, 40W maximum incandescent bulbs.

7

Image 7
Contents Quick Reference Table of ContentsImportant Observe all governing codes and ordinances Tools and materials needed for installationMobile home installation Before you startHorizontal wall venting Product dimensionsVenting requirements Vertical roof ventingRecommended standard fittings Now startPrepare hood 4 x 10 8.3 x 25.4 cm vent system17.8 cm Prepare the hood4 x 10 8.3 x 25.4 cm Vent systemRectangular vent only Install the hoodFollow Power Cord Kit instructions for connecting wiring Make electrical connectionBulbs must be purchased separately Use and Care InformationOperation Replacing Halogen bulbsTo clean hood Whirlpool Range Hood WarrantyCleaning Charcoal filters non-vented installationsOur consultants provide assistance with Requesting Assistance or ServiceListed in Check Operation If you need serviceSérie GZ5736 Consultation rapideTable des matières Série GZ5730Installation dans une résidence mobile Outillage et matériel nécessaires pour l’installationAvant de Commencer Le système doit décharger l’air à l’extérieur Dimensions du produitLongueur recommandée du circuit d’évacuation Préparation de l’emplacement de l’installationVERTICAL/RECTANGULAIRE 8,3 x 25,4 cm 3 1/4 x 10 po Préparation de la hotteAu réseau électrique » Avertissement Installation de la hotteOn doit acheter les lampes séparément Utilisation et entretienUtilisation de la hotte Garantie Whirlpool Hotte d’extractionNettoyage Pour plus d’assistance Demande d’assistance ou de serviceSi vous avez besoin d’assistance ou de service aux É.-U Si vous avez besoin de pièces de rechangeSi vous avez besoin de service Si vous avez besoin d’assistance ou de service au Canada« Dépannage »

GZ5730, GZ5736 specifications

The Whirlpool GZ5736 and GZ5730 are part of Whirlpool's innovative lineup of refrigerators designed to enhance kitchen convenience while promoting energy efficiency and modern aesthetics. Both models are engineered with advanced technologies that focus on user experience, ensuring that food storage becomes a seamless part of daily life.

One of the prominent features of the GZ5736 and GZ5730 is their Adaptive Defrost system. This groundbreaking technology monitors the usage patterns of the refrigerator, allowing it to run the defrost cycle only when necessary, thus conserving energy and maintaining optimal food preservation conditions. This not only prolongs the lifespan of the appliance but also results in lower energy bills.

Another significant aspect of these models is their improved cooling system. Equipped with a multi-air flow system, these refrigerators ensure consistent temperature distribution throughout the fridge and freezer compartments. This helps maintain the freshness of groceries while minimizing temperature fluctuations that could lead to spoilage.

The GZ5736 and GZ5730 models boast spacious storage solutions. They feature adjustable shelves that allow users to customize their space according to their needs. This flexibility accommodates larger items, such as tall bottles or bulk grocery purchases, ensuring that every inch of space is utilized efficiently. The door bins are designed for easy access, providing quick retrieval of frequently used items like condiments and beverages.

Both refrigerators also come with an innovative humidity-controlled crisper drawer. This unique feature helps keep fruits and vegetables fresh longer by regulating humidity levels, creating an ideal environment for produce storage.

In terms of energy efficiency, the Whirlpool GZ5736 and GZ5730 exceed ENERGY STAR guidelines, embodying Whirlpool's commitment to sustainability. Users can feel confident that they are making a responsible choice without compromising on performance.

Additionally, these models come equipped with intuitive LED lighting, illuminating the refrigerator's interior and allowing for easy visibility of contents, even in dim light. This enhances the overall user experience by making it convenient to locate items quickly.

In summary, the Whirlpool GZ5736 and GZ5730 refrigerators combine advanced technology, energy efficiency, and user-friendly features to provide exceptional food storage solutions. With their sleek design, innovative cooling systems, and customizable space, they are ideal choices for modern households looking to blend practicality with style.