Hobart 2812 manual LUBRICATION - Carriage Slide Rod and Sharpener, Overload Reset Button - Model

LUBRICATION — Carriage Slide Rod and Sharpener

Lubricate the Carriage Slide Rod with Lubriplate FMO-200-AW oil (supplied). Either squirt 8 – 10 drops every 2 – 3 months (depending on usage) in the Wick Hole on the Carriage Transport (Fig.12). Or, once monthly, apply 4 – 5 drops directly on the Carriage Slide Rod on each side of the Carriage Transport (Fig.12).

To apply oil, pull out the telescoping tube on the oil bottle, aim the tube, and squeeze gently on the sides of the bottle. After applying oil, move the Carriage Tray back and forth a few times so the oil spreads over the entire length of the slide rod.

Also, apply 1 drop on both slots of the sharpener plunger and on the sharpener shaft (Fig. 13).

OVERLOAD RESET BUTTON — MODEL 2912

Push the reset button underneath the slicer near the right-front foot if the carriage motor overloads.

SERVICE

Contact your local Hobart-authorized service office for any repairs or adjustments needed on this equipment.

Fig. 12

Fig. 13

FORM 35203 Rev A (Nov. 2004) – 16 – PRINTED IN U.S.A.