I | TROUBLESHOOTING | I |
1. Indicators |
|
|
[f a malfunction or a misfeed occurs within the machine, the following indicators will light.
-Check the misfeed or malfunction location.
Open the top unit cover, remove original and reset. (See page 43.)
Remove the jammed paper and press the Reset key. (See page 44.)
Remove the jammed master and pressthe Resetkey. (Seepage 45.)
Open the master eject unit and remove any jammed paper, then press the Reset key. If the paper is stuck to the drum, pull out the drum unit until the drum unit hits the drum stopper, and remove the jammed paper from the drum. (See page 46.)
1.If the paper is stuck to the drum, pull out the drum unit until the drum unit hits the drum stopper, and remove the jammed paper from the drum.
2.If the jam is in the paper feed section, the jammed paper may be cleared at either the paper entrance or the paper exit side.
(See page 47.)
Open the master eject unit and remove the jammed master. Press Reset key. If the jammed master is stuck to the drum, pull out the drum unit and remove the misfed master. (See page 48.)
Open the master eject unit and remove the jammed paper. Press Reset key. (See page 48.)
Check that the original is correctly placed and that the counter is set for the required number of copies. (See page 49.)
Load paper. (See page 49.)
Load new master roll. (See page 49.)
Load new ink cartridge. (See page 50.)
1.Remove the used masters inside the master eject box.
2.Make sure the master eject box is replaced correctly. (See page 50.)
Check the setting of the original table, the front cover, the master eject
unit,the drum, the paper feed table, and the top unit. (Seepage 51.) Color drum is installed.(See page 51.)
Set the key counter. (See page 51.)
If a service code (EO1– E08) is displayed in the counter, please contact your service representative.
42
