MAINTENANCE
1. Thermal Head Cleaning
Clean the thermal head when 2 master rolls have been used.
1.Turn off the main switch.
2.Open the original table. (See page 38.)
3.Move the pressure release lever in the direction of the arrow. (See page 38.)
4.Loosen the screw knobs located on both sides of the feed roller.
5.Grip both ends of the feed roller and lift it straight up.
6.Clean the thermal head as follows.
I) Wipethe surfaceof the thermal head with a damp cloth.
2) Cleanthe surfaceof thermal head several times usingthe cleaner pen with cleaning
solution. (The cleaner pen is stored in the carton box as an accessory.)
3) Dry the surface of thermal head with a clean dry cloth.
I | I | I | Make sure to replace the cap of |
I |
| Warning: | |
|
| cleaner | after using it. |
. Replace the felt of the cleaner pen if it be- comes ditty.
7.Install the feed roller by reversing the above procedure.
. Make sure to tighten the screw knobs on both sides of the feed roller.
40
