5.Using 2 or more people, remove the cooktop from the carton.
6.Use foam end caps from the packaging as a work surface for the floor or countertop.
7.Using 2 or more people, place the cooktop upside down on the foam end caps.
8.Make sure knobs are positioned in the open areas of the end caps.
9.Avoid placing the cooktop facedown on the control knobs.
To rotate blower:
1.Locate the four plastic plugs in the plenum bypass.
2.Use the pliers to remove the plastic plugs.
IMPORTANT: Do not throw away the plastic plugs. The plastic plugs must be reinstalled after the blower exhaust scroll has been rotated.
Install Foam Strip
1.Remove foam strip from the package containing literature.
2.Remove backing from foam strip.
3.Apply foam strip
NOTE: The foam strip keeps the underside of the cooktop glass free from debris and helps the cooktop sit flat on uneven counters.
A |
B |
C |
A. Cooktop base
B. Foam strip
C. Glass
Rotate Blower - Optional
IMPORTANT: The following additional steps must be performed if the product is being installed in peninsula or island cabinetry.
The blower exhaust scroll is shipped from the factory set to exhaust straight out the back of the cabinet through an exterior wall.
A | E |
| |
B | E |
C | D |
| |
A. Blower motor | D. Blower bypass |
B. Exhaust scroll | E. Plastic plugs (4) |
C.Plenum
3.Insert the ³⁄₈" socket and extension into the hole and use the ratchet handle to loosen the nut half of a rotation. Repeat this process for each of the four nuts.
4.With the nuts loosened, the blower exhaust scroll can be easily rotated downward.
5.Retighten each nut with the ³⁄₈" socket, extension and ratchet.
6.Reinstall the four plastic plugs.
|
|
| Install Cooktop |
|
| 1. | Using 2 or more people, place cooktop right side up into the |
|
|
| cutout. |
|
|
| NOTE: Make sure that the front edge of the cooktop is |
|
|
| parallel to the front edge of the countertop. If repositioning is |
|
|
| needed, lift entire cooktop up from the cutout to avoid |
B | B |
| scratching the countertop. |
| 2. | For island or peninsula installations, go to “Rotate Blower - | |
|
| ||
| C |
| Optional” section. |
|
| 3. | Connect blower exhaust scroll to ducting. |
|
| 4. | Use vent clamps to secure the ducting to the blower exhaust |
|
|
| scroll. |
|
| 5. | Reinstall removable grease filter. |
| D | 6. | Reinstall vent grille. |
A | E |
|
|
|
|
| |
A. Blower exhaust scroll | C. Plenum |
|
|
B. | D. Motor mounting plate |
|
|
| E. Blower motor |
|
|
8