Sanyo MBR-704GR instruction manual May result

Page 6

PRECAUTIONS FOR SAFE OPERATION

CAUTION

Fix the shelves securely. Incomplete installation may cause injury or damage.

When removing the plug from the power supply outlet, grip the power supply plug, not the cord.

Pulling the cord may result in electric shock or fire by short circuit.

Never damage or break the power supply plug or cord. Do not use the supply plug if its cord is loose. This may cause fire or electric shock.

Do not touch any electrical parts such as the power supply plug or any switches with a wet hand. This may cause electric shock.

Do not put a container with water or heavy articles on the unit. Injury may be caused if the articles fall. Current leakage or electric shock may result from the introduction of spilled water into

electrical components.

Do not climb onto the unit. This may cause damage to the unit and cause it to tip over.

Hold the handle when closing the door. This will reduce the likelihood of a trapped finger.

Do not lean on the door. This may cause injury if the unit tips over.

Never place your hand on the glass or use excessive force on the glass. Intentional force may break the glass resulting in injury from the broken glass.

Do not touch the condenser directly when the filter is removed for cleaning. This may cause injury due to hot surface.

Disconnect the power supply plug before moving the unit. Take care not to damage the power cord. A damaged cord may cause electric shock or fire.

Dispose of any water in the evaporation tray completely before moving the unit. Spilled or

splashed water may cause current leakage or electric shock.

Be careful not to tip the unit over during movement to prevent damage or injury.

Disconnect the power plug when the unit is not used for long periods.

Do not put the packing plastic bag used in the packaging within reach of children as suffocation

may result

5

Image 6
Contents MBR-704G MBR-704GR Precautions for Safe Operation Contents Symbol shows Precautions for Safe Operation Prevent electric shock or injury May result Environmental Conditions Refrigerator Components Inner door Upper monitor bottle Lower monitor bottle Inside of front cover Inside components of MBR-704G typeControl panel and keypad Installation Installation siteInstallation Fix the unitGround earth Preparation of monitor bottle Exhaust air vent START-UP of UnitStock of containers Load lineOperating Instructions Control panelDefrost cycles Temperature sensor calibration procedure Alarms and safety functions Alarms & Safety FunctionsRemote alarm terminal Alarm test procedureRoutine Maintenance Cleaning of cabinetCleaning of evaporation tray Replacement of fluorescent lamp Replacement of glow starterDisposal of Unit Alarm device is activated Trouble ShootingIf nothing operates even when switched on When the unit does not get cold enoughSpecifications PerformanceSafety check sheet CEM