II. Maintenance Monthly | Middleby Marshall PS555G GAS specs

ENGLISH

SECTION4-MAINTENANCE

II. MAINTENANCE - MONTHLY

NOTE

When removing the conveyor, refer to Figure 2-9 (in Section 2, Installation).

A.Check that the oven is cool and the power is disconnected, as described in the warning at the beginning of this Section.

B.Remove the crumb trays and drive motor shroud from the oven.

C.Lift the drive end of the conveyor slightly, and push it forward into the oven. This removes the tension from the drive chain. Then, remove the drive chain from the conveyor sprocket.

D.Slide the conveyor out of the oven, folding it as it is removed.

NOTE

Split belt conveyors can only be removed from the end of the oven with the drive motor.

Single-belt conveyor assemblies may be removed from either end of the oven. If it is to be removed from the end of the oven without the drive motor, remove the drive motor sprocket as described in the Conveyor Installation instruc- tions (in Section 2, Installation).

E.Remove the end plugs from the oven. The end plugs are shown in Figure 1-1 (in Section 1, Description).

F.Slide the air fingers and blank plates out of the oven, as shown in Figure 4-3. AS EACH FINGER OR PLATE IS REMOVED, WRITE A "LOCATION CODE" ON IT WITH A MARKER to make sure that it can be reinstalled correctly.

Example of markings:

(Top Row) T1 T2 T3 T4 T5 T6 (Bottom Row) B1 B2 B3 B4 B5 B6

G.Disassemble the air fingers as shown in Figure 4-4. AS EACH FINGER IS DISASSEMBLED, WRITE THE "LOCA- TION CODE" FOR THE FINGER ON ALL THREE OF ITS PIECES. This will help you in correctly reassembling the air fingers.

CAUTION

Incorrect reassembly of the air fingers will change the baking properties of the oven.

H.Clean the air finger components and the interior of the baking chamber using a vacuum cleaner and a damp cloth. Refer to the boxed warnings at the beginning of this Section for cleaning precautions.

I.Reassemble the air fingers. Then, replace them in the oven, using the "location code" as a guide.

J.Replace the end plugs on the oven.

K.Reassemble the conveyor into the oven. If the drive sprocket was removed when installing the conveyor, replace it at this time.

L.Reattach the drive chain.

M.Check the tension of the conveyor belt as shown in Figure 2-10 (in Section 2, Installation). The belt should lift between 3-4" (75-100mm). DO NOT OVERTIGHTEN THE CON- VEYOR BELT. If necessary, the belt tension can be ad- justed by turning the conveyor adjustment screws, located at the idler (right) end of the conveyor.

N.Replace the crumb trays and drive motor shroud.

Figure 4-3 - Removing Air Fingers and Plates

Figure 4-4 - Disassembling the Air Fingers

Manifold

Inner plate

Outer Plate

Pull outer plate	3
straight up
and off	Swing ends of inner plate and
	manifold apart

Pull inner plate upwards, and then away from manifold

Step on lip of manifold