2.If you have not already done so, remove the motor drive cover from the power unit’s mono drive (see figure 5a) and place the stainless steel mixing bowl on the mono drive of the power unit. Turn the bowl counterclockwise with a slight downward pressure until bowl is firmly seated on the mono drive coupling, see figure 5b.
CAUTION
Failure to make sure that the bowl is properly seated on the mono drive coupling before the power unit is turned On can result in damage to the bowl and/or coupling.
Figure 5.
3.Engage the dough hook on the driveshaft of the mixing bowl by placing it over the center column, as shown in figure 6a. Once in place, check to make sure the dough hook has engaged the driveshaft by turning the dough hook clockwise while pushing down until it stops.
Figure 6.
4.Place the
The cover has an integral filling funnel with a cap. The funnel cap may be removed to add ingredients, but the cover and cap should be in place whenever the power unit is in operation. The
Placing into Operation w/Dough Hook
Make sure that the power unit is on a smooth, clean, suitable work surface and switched to the Off position, “O/Off.” Unwind the electrical cord to the necessary length and plug into a convenient outlet. The mixing bowl with dough hook is now ready for operation. See table 1 for examples demonstrating the use of the dough hook attachment. Sample recipes may also be found in the recipe section, at the back of this manual.
How to Use Twin Beating Whisks
The Bosch Concept 7400 Kitchen Machine also comes with a twin beating whisk assembly, see figure 3c.
The twin beating whisks and mixing bowl are intended to be used for very light substances, such as cream, egg whites, sauces, batters and light pastry doughs that are thin enough to pour.
11