Four rubber feet
Four rubber feet with formed suction cups provide the ultimate in stability, while also serving to isolate the power unit from the hard surface to minimize noise and vibration. Need clean smooth surface, see figure 2h.
Getting Started
The operation of your Bosch Concept Series Kitchen Machine is summarized below.
Specific instructions for using each of the attachments, provided with Bosch Concept 7400 Kitchen Machine follow this summary. Please read the specific instructions thoroughly before using that attachment, paying particular attention to the IMPORTANT SAFEGUARDS and WARNINGS provided.
1.Place power unit on suitable work surface.
Before using the machine with any of the attachments, the power unit should be placed on a suitable work surface. The surface should be sturdy, smooth and clean; make sure that there is no flour or oil on the surface. A clean smooth surface will provide the best footing for the suction cup feet on the power unit and will limit slipping and/or “walking.”
2.Plug power unit into power supply. Unwind the power unit’s cord to appropriate length and plug it into a convenient nearby receptacle.
3.Remove motor drive cover. Remove motor drive cover from mono- drive.
4.Select the attachment to be used. Select attachment you wish to use and place on power unit. See specific instructions for attachment selected. Specific instructions are located on pages listed below:
Attachment | Pages |
|
|
Mixing bowl w/dough hook | |
Mixing bowl w/twin whisks | |
Blender |
Table 1.
5.Operate unit
Once the attachment is in place, the power unit may be operated. The power may be manually turned on and off using the rotary switch or operating time may be controlled using the timer.
Using the timer
The operation of the power unit can be set to turn off automatically after a set time (maximum on time is 30 minutes). The length of time of operation may be selected with the appliance either already on and running, or with rotary switch in Off, “O/Off,” position; power unit must, however, be plugged in.
To use timer function:
1.Turn on the timer function by depressing the “time on” button, see figure 2b. The display will show minutes and seconds separated by a colon. The initial display will be “00:00” with the separating colon flashing.
2.Select the operating time desired by pressing the “+” button to increase the time in
Holding either button down for more than 2 seconds will cause the time to increase or decrease rapidly. Also, if the running time desired is close to 30 minutes, the timer can quickly be set to 30 minutes by
7