Removing Contents
Before beginning to remove the contents from the mixing bowl, make sure that the power unit has been turned to the Off position, “O/Off.” Remove the cover and splash ring by turning clockwise and lifting off. Once the cover and splash ring have been removed, the dough hook or the twin beating whisks may be removed by turning the hook or whisk assembly clockwise while lifting.
The mixing bowl can be removed from the power unit by turning the bowl clockwise while lifting.
The contents may now be used as desired.
Care and Cleaning
of Bowl and Its Accessories
Except for the whisk holder and the dough hook, the mixing bowl and its accessories are dishwasher safe.
It is recommended that the whisk holder and the dough hook be washed by hand in warm soapy water, rinsed well and dried after each use. The whisks can be removed from the whisk holder by simply pulling them off, see figure 7a.
Blender with Unbreakable Plastic Jar (MUZ 7 MX1)
WARNING
1.There is a risk of injury from sharp blades when using the blender attachment.
2.Keep hands and utensils out of the blender jar while it is attached to the power unit.
3.Blades are sharp. Handle carefully.
4.To avoid injury, never place blade assembly on power unit without blender jar properly attached.
5.Always operate the blender with the cover in place. Always hold cover in place while operating the blender to prevent cover from coming loose.
6.The use of attachments, including canning jars, not recommended by the manufacturer, may cause a risk of personal injury.
7.When blending hot and/or frothing liquids, process a maximum of 18 fluid ounces (0.5 litres) at a time.
Figure 7.
After washing, rinsing and drying, the whisks may be placed back on the whisk holder by reversing the action to remove them, see figure 7b. Press them on until they snap into place.
The power unit of the kitchen machine should be cleaned using a clean, damp cloth only. Never use coarse or caustic cleaning products to clean this appliance. Never immerse the power unit in water.
Figure 8. |
|
8a. | Cover closure/funnel |
8b. | Cover |
8c. | Blender jar |
8d. | Gasket |
8e. | Blade/base assembly |
14