Maytag W10240116A warranty Heated dry, Controls Cycle Status Control Purpose Comments

OPTION SELECTIONS

OPTIONS	DISH LOAD TYPES	DESCRIPTIONS	USE WITH:
Heated dry	Heated dry: For best	Turn OFF when loads contain plastic dinnerware that may be	Heavy, Normal, Light, or
	drying results, dry dishes	sensitive to high temperatures.	Auto Clean Plus
	with heat.	This option with the use of rinse aid will provide the best
		drying performance.
	To sanitize your dishes and	Raises the water temperature in the final rinse to	Heavy, Normal, Light, or
	glassware in accordance	approximately 154°F (68°C). This high temperature rinse	Auto Clean Plus
	with NSF/ANSI Standard	sanitizes your dishes and glassware in accordance with
	184 for Residential	NSF/ANSI Standard 184 for Residential Dishwashers.
	Dishwashers.	Certified residential dishwashers are not intended for
		licensed food establishments.
		The Sanitize option adds heat and time to the cycle.
	To run your dishwasher at	Delays the start of a cycle up to 6 hours.	All cycles
	a later time or during off-	Select a wash cycle and options. Press Delay. Press START/
	peak hours.
		RESUME. Close the door firmly within 3 seconds. For fully
		integrated models ((controls on top of console).

Control Lock To avoid unintended use of your dishwasher, or cycle

and option changes during a cycle.

To turn on Lock, press and hold Heated Dry for at least	Anytime
3 seconds.
To turn off Lock, press and hold Heated Dry for at least
3 seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
5 times. The dishwasher door can be opened while the
controls are locked.

IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically compensate by adding time, heat and water as needed.

CONTROLS AND

CYCLE STATUS

CONTROL PURPOSE COMMENTS

To start or resume a wash cycle

If the door is opened during a cycle or the power is interrupted, all lights will flash to indicate a suspended cycle. The cycle will not resume until the door is closed, and the START/RESUME button is pushed.

To cancel wash	Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
cycle	drain completely.

To follow the progress and status of your dishwasher cycle

The “Clean” indicator glows when a cycle is finished.

If you select the Sanitize option, when the Sanitize cycle is finished, the Sanitized indicator glows. If your dishwasher did not properly sanitize your dishes, the light will be blinking. This can happen if the cycle is interrupted, or the water could not be heated to the required temperature. The clean and sanitize lights go off when the door has been opened for more than 30 seconds or the CANCEL key is pressed.

The “Washing” indicator glows at the start of the first fill of any cycle (except Rinse Only) and remains on until the end of the main wash cycle.

The “Drying” indicator glows during the drying portion of each cycle (except Rinse Only).

6