Maytag W10240116A Problem Solution Water Remains in the TUB, Will not Drain, Glassware, Odors

PROBLEM	SOLUTION
WATER REMAINS IN THE TUB/	Be sure the cycle has completed (the green light is on). If the cycle has not completed, you will need
WILL NOT DRAIN	to resume the cycle by pressing START/RESUME and closing the door within 3 seconds.
	If dishwasher is connected to a food waste disposer, be sure the knockout plug has been removed
	from the disposer inlet.
	Check for kinks in the drain hose.
	Check for food obstructions in the drain or disposer.
	Check your house fuse or circuit breaker.
HARD WATER	NOTE: Extremely hard water mineral deposits can cause damage to your dishwasher and make it
(WHITE RESIDUE ON	difficult to achieve good cleaning. A water softener is strongly recommended if your hardness is
DISHWASHER INTERIOR OR	15 grains or more. If a water softener is not installed, the following steps may help:
GLASSWARE)	Use a commercial cleaner designed for dishwashers once per month.
	Always use a rinse aid.
	Always use a high-quality, fresh detergent.
	Use a detergent booster/water softener additive designed for dishwashers.
ODORS	NOTE: If the dishwasher is not used daily, you can run a rinse cycle with the partial load daily until a
	full load is ready to run.
	Run a vinegar rinse through the dishwasher by putting 2 cups (500 mL) of white vinegar in an
	upright glass measuring cup in the lower rack. Run a normal cycle with the Heated Dry option
	turned off. Do not use detergent.
	The dishwasher may not be draining properly, see “WATER REMAINS IN THE TUB/WILL NOT
	DRAIN” in “Troubleshooting.”
NOISY	NOTES:
	■ Surging sounds can occur periodically throughout the cycle while the dishwasher is draining.
	■ Normal water valve hissing may be heard periodically.
	■ A normal snap sound may be heard when the detergent dispenser opens during the cycle and
	when the door is opened at the end of the cycle.
	■ Improper installation will affect noise levels.
	Be sure the filters are properly installed.
	A thumping sound may be heard if items extend beyond the racks and interfere with the wash arms.
	Readjust the dishware and resume the cycle.
FOOD SOILS REMAIN	Be sure the dishwasher is loaded correctly. Improper loading can greatly decrease the washing
ON DISHES	performance (see “Prepare and Load the Dishwasher”).
	Select the proper cycle and option for the type of soils. The Pots Pans cycle with the Hi Temp
	option can be used for tougher loads.
	Be sure the incoming water temperature is at least 120°F (49ºC).
	Use the proper amount of fresh detergent. More detergent is needed for heavier-soiled loads and
	hard water conditions.
	Scrape food from dishes prior to loading (do not prerinse).
DID NOT SANITIZE	If the sanitized light is blinking, the load is NOT sanitized. The cycle was interrupted in the final
	rinse, or your water heater is set too low. Set your water heater to 120ºF (49ºC).
DAMAGE TO DISHWARE	Improper loading can cause dishes to become chipped or damaged. (See specific loading
	instructions within this guide.)
BLINKING LIGHTS	If the START/RESUME light is blinking, press START/RESUME and close the door within 3 seconds.
	If the Clean light or any other lights are blinking and the dishwasher will not run, call for service.

10