Bunn Plumbing Hookup, Plumbing Connections JDF-2S Plumbing Connections JDF-4S, Initial Fill

PLUMBING HOOKUP

The plumbing connection is located on the rear of the dispenser. A 3/8" (9.52 mm) male flare adapter fitting is supplied, installed on the rear of the dispenser.

P3580-1	P3841
FIG 1 Plumbing Connections - JDF-2S	FIG 2 Plumbing Connections - JDF-4S

INITIAL FILL

CAUTION: The dispenser must be disconnected from the power source throughout the initial fill except when specified in the instructions.

1.Remove drip tray assembly and splash panel from the dispenser. Replace the drip tray.

2.Connect the water source to the back of the dispenser.

3.Pull the fill tube from the dispenser, remove the plug and connect it to the dispense nozzle.

4.Place the Dispense Lockout switch in the OFF position.

5.Connect dispenser to the power source. Press and hold the dispense button for the dispense station that the tube is connected to for 10 seconds, until you hear the water valve turn on.

6.Monitor the water bath fill level until water starts to trickle from the overflow tube. Then press the dispense button again to stop the fill process.

NOTE: The fill timer may time out before filling is complete. Press and hold the dispense button for 10 seconds to start again if needed.

	P3581-1	FIG	P3846
FIG 3 Initial Fill Hose - JDF-2S			4 Initial Fill Hose - JDF-4S

39992 042007