OPERATING CONTROLS
Refrigeration Switch
The refrigeration switch is located on the rear of the dispenser near the center. This switch controls power to the water bath pump and relay contacts for the compressor and condenser fan motor.
P3841 | |
FIG 7 Refrigeration Switch - | FIG 8 Refrigeration Switch - |
| P3583 | P3844 |
|
| |
FIG 9 Product Dispense Switches - |
| FIG 10 Product Dispense Switches - |
A.Product Dispense Switch
Pressing and holding switch will initiate product flow from the respective nozzle; releasing the switch will stop the flow.
B.Dispense Lockout Switch
This switch is located at the bottom front of the dispenser just behind the drip tray. It is used to turn ON and OFF the Dispensing function. It is also used for some programming and fill procedures.
P3612
FIG 11 Dispense Lockout Switch
DISPENSER USE
Press and Hold Dispensing:
1.Place a cup on the drip tray beneath the desired dispensing nozzle.
2.Press and hold the “Product Dispense” switch until the beverage reaches the desired level, then release.
39992 042007