Extron electronic MTP 15HD manual Receiver DIP Switch Settings

FDIP switches (RL receivers only) — A 6-pole DIP switch is used to configure the features of the MTP receivers.

•• Horizontal sync (H Sync +) switch — Set this switch On (up) for positive horizontal sync or Off (down) for negative sync.

•• Vertical sync (V Sync +) switch — Set this switch On (up) for positive vertical sync or Off (down) for negative sync.

NOTE: For H Sync + and V Sync +, most devices use negative sync.

•• Composite Sync (C Sync) switch — Set this switch up for RGBS or down to output RGBHV or RGsB video (see figure 7).

Input signal	Output signal	Receiver DIP
format to the	format from	switch settings
transmitter	the receiver	C Sync SOG Video
	RGBHV
RGBHV	RGBS
	RGsB
RGBS	RGBS
	RGsB
RsGsBs	RsGsBs
RGsB	RGsB
Component	Component
S-video	S-video
Composite	Composite

Figure 7. Receiver DIP Switch Settings

•• Sync-on-Green (SOG) switch — Set this switch up for RGsB video (when the input is RGBHV or RGBS) or down to output RGBHV, RsGsBs, or RGBS video (see figure 7).

•• Video switch — Set this switch up for RsGsBs, RGsB, component video / S-video / composite video or down to output RGBHV or RGBS video (see figure 7).

NOTE: Set the Composite Sync, SOG, and Video DIP switches as shown in figure 7 for the various input and output video formats

•• End Unit switch — Set this switch On (up) if either of the following is true:

•• The receiver being configured is the only receiver connected to the transmitter.

•• The receiver being configured is the last receiver in a daisy-chained system.

Set the End Unit switch Off (down) on the receiver being configured if there are one or more receivers connected to the Buffered Output RJ-45 connector.

MTP 15HD RS Series • Installation and Operation 11