Bunn LCA-1, LCR-1 service manual Troubleshooting Guide, Error Codes, LED Display Error

TROUBLESHOOTING GUIDE

Error Codes

When an error has occurred, the Warning LED will be flashing. Open the door to view the LED Display and record the Error # shown on the display. Refer to the list of Error Codes below to identify the problem. The troubleshooting guide is provided to suggest probable causes and remedies for most problems. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department.

LED DISPLAY

E_01

E_02

E_ 0 3

E_04

E_ 0 5

ERROR	DESCRIPTION/TROUBLESHOOTING
Pump Error	Motor or RPM Sensor failure. Check
	motor and RPM
	Sensor wires for shorts, loose or open
	connections.
Heating Time Too Long	Tank Heater ON continuous for more
	than 1 hour.
	Check heater wires for loose or open
	connections.
Fill Time Too Long	Fill Valve ON continuous for more than
	15 minutes.
	Water turned OFF. Refill Valve
	disconnected or faulty.
Tank Temp Sensor Error	Sensor reading Out Of Range (High
	or Low).
	Check Sensor wires for shorts, loose
	or open connections.
Dispense Time Too Long	Dispense or Hot Water switch has been
	ON for more than 2 Min.
	Check: Dispense switches for proper
	operation or damage. Door harness
	for shorts.

19 44806.1 081211