Bunn LCR-1 User Notices, 00656.0001, 27442.0000, 33461.0005 11646.0002, 00824.0002 40054.0003

Page 4

USER NOTICES

Carefully read and follow all notices on the equipment and in this manual. They were written for your protec- tion. All notices are to be kept in good condition. Replace any unreadable or damaged labels.

00986.0002

37881.0000

As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow prevention to comply with federal, state and local codes. For models installed outside the U.S.A., you must comply with the applicable Plumb- ing /Sanitation Code for your area.

00656.0001

Moving Parts.

Risk Of Electrical Shock.

Do not operate

Disconnect power before

unit with this

servicing unit.

panel removed.

 

 

 

27442.0000

CHARGE

Type R134A, Amount 5 oz (141.7 gm)

Design Pressures:

High 269 psi (18.5 bar) (1.8 MPa)

Low 90 psi (6.2 bar) (0.62 MPa)

33461.0005

11646.0002

REMINDER!

CLEAN AIR FILTER

WEEKLY

RECORDATORIO!

LIMPIAR EL FILTRO DE

AIRE SEMANALMENTE

00824.0002

40054.0003

4

44806.1 081211

 

Image 4
Contents LCR-1 LCA-1 Phone 217 529-6601 FAX 217BUNN-O-MATIC Commercial Product Warranty Contents User Notices 00656.000127442.0000 33461.0005 11646.0002Electrical Requirements IntroductionPlumbing Requirements Initial SET-UP Locating the DispenserPlumbing HOOK-UP Electrical HOOK-UPOperating Controls and Interface User InterfaceOperating Controls and Interface Installing the Pump Tubing Installing Pump TubingPriming the Concentrate Line Initial Fill & Heat Cabinet Target Temperature LCR-1 Only Rinse Alarm FeatureLevel Selected Alarm Programming the Dispenser Display Mode DescriptionLED Display Program Mode Description Programming the DispenserOperating the Dispenser General Cleaning and Sanitizing Procedures Daily RinsingDaily Parts Washing Weekly SanitizingPreventive Maintenance Cleaning the AIR Filter LCR-1 OnlyReplacing the Pump Tubing Replacing the Water FilterCalibration Mode  DESCRIPTION Calibrating the DispenserReset Factory Defaults Default settingReset by holding the Decrease Calibrating the DispenserError Codes Troubleshooting GuideLED Display Error Follow errors codes apply to the LCR-1 only Troubleshooting Guide Error CodesDESCRIPTION/TROUBLESHOOTING Calibration of the Concentrate Pump & Dispenser Flow Rate Calibrating the Concentrate PumpsDraining the HOT Water Tank Calibration of the Concentrate Pump & Dispenser Flow RateCalibrating the Dispenser Flow Rates Schematic Wiring Diagram LCR-1 / LCA-1 Tank Heater