SERVICE (cont.)
LIGHTED ON/OFF SWITCH (TB3/TB3Q)
P/N 37080.0000
Orange light
FIG. 14-1 LIGHTED ON/OFF SWITCH
Location:
The ON/OFF switch is located in the front of the hood, above and to the left of the brew funnel.
Test Procedure:
Brewers W/Out Half Batch or Sweetener Options
1.Disconnect the brewer from the power source.
2.Remove the wires from all four terminals.
3.Check for continuity across the two terminals on the lower right of the switch (as shown). Continuity must be present across these terminals in the ON position.
If continuity is present as described, reconnect the wires, the switch is operating properly. If continuity is not present as described, replace the switch.
NOTE: No continuity will show across the upper left terminals of the lighted switch since the light is neon.
Removal and Replacement:
1.Remove the wires from the switch terminals.
2.Compress the clips inside the hood and gently push the switch through the opening.
3.Push the new switch into the opening and spread the clips to hold the switch captive in the hood.
4.Refer to FIG. 14-2 when reconnecting the wires.
BLACK
WHITE
WHT/VIO
P/N 37080.0000
2 WHT/VIO
FIG. 14-2 LIGHTED ON/OFF SWITCH TERMINALS
Page 14 | 41722 070209 |
|