Bunn 40410.0000G Programming Smart Wave with Display, Advanced SET-UP, Technician SET-UP

PROGRAMMING - SMART WAVE WITH DISPLAY

BREW VOLUME SET-UP:

NOTE: Maximum water on time is 5 minutes.

1.Press the "HIDDEN" switch until display reads A1. This represents the adjust mode "Brew Time" for the "A" brew switch. The display will then change to (minutes-seconds). Press "BREW A" to decrease time (-) or "BREW B" to increase time (+).

2.Press and release "HIDDEN" switch until display reads A2. This represents the adjust mode "Brew Meter" (Pulse Brew) for the "A" brew switch. The display will then change to (1-14). Brewer has 14 preset pulse brew routines to choose from. Factory default is 1. With 14 being the maximum time. Press "BREW A" to decrease (-) or "BREW B" to increase (+).

3.Press and release "HIDDEN" switch until display reads A3. This represents the adjust mode "Drip Out Time" for the "A" brew switch. The display will then change to (minutes-seconds). Press "BREW A" to decrease time (-) or "BREW B" to increase time (+).

4.Repeat steps 1 -3 for setting the "B" brew switch.

	Adjustment	Default	Min.	Max.	Increments
A1	= Brew switch "A" Brew time	2:05	0:26	5:00	1 second
A2	= Brew switch "A" Brew meter	1	1	14	1
A3	= Brew switch "A" Drip out time	1:00	0:05	5:00	5 seconds
B1	= Brew switch "B" Brew time	2:05	0:26	5:00	1 second
B2	= Brew switch "B" Brew meter	1	1	14	1
B3	= Brew switch "B" Drip out time	1:00	0:05	5:00	5 seconds

ADVANCED SET-UP:

Press the "HIDDEN" switch until display reads P1. This represents the advanced adjust modes .

	Adjustment	Default	Min.	Max.	Increments
P1	= Temperature set	200°F	185°F	205°F	1	Degree
P2	= Ready Temperature	195°F	180°F	198°F	1	Degree
P3	= Brew Count (Display Only)	0	0	9999	1	Brew Cycle
P4	= °F or °C	°F	N/A	N/A	N/A

TECHNICIAN SET-UP:

Press the "HIDDEN" switch until display reads U1. This represents the Technician adjust modes .

	Adjustment	Default	Min.	Max.	Increments
U1	= Display Water Level Threshhold	< 10	0	255	1
U2	= Adjust Water Level Threshhold	85	30	220	1
U3	- U7 FACTORY ADJUSTMENTS		DO NOT	ADJUST
U8	= Calibrate Temperature Sensor	200°F	190°F	210°F	1°

Restore Factory Defaults:

Press the "ENABLE BREW ON/OFF" switch while applying AC power. Continue pressing the "ENABLE BREW ON/ OFF" switch for 10 seconds. During that 10 seconds the middle bars on the display will be on. After 10 Seconds the the 3 upper, middle and lower bars on the display will be lit for 5 seconds. During that 5 seconds, release and again press the "ENABLE BREW ON/OFF" switch to restore default settings – the display will show “DONE”.

Note: The Restore process cannot be done when Dip Switch # 1 is On (Program Lockout).

Page 11 40410 092211