Bunn 40410.0000G service manual Cleaning Optional Large Sprayhead

Page 13

CLEANING

The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment.

CLEANING OPTIONAL LARGE SPRAYHEAD

1.Remove the brew funnel.

2.Remove the sprayhead by turning it counterclockwise with your fingertips.

3.Disassemble sprayhead by removing rubber gasket.

4.Check the holes in the sprayhead. If plugged by lime, they may be cleared using a toothpick. Rinse the sprayhead with water.

5.Reassemble the sprayhead according to FIG 11. NOTE: Verify the indents are aligned. (ARROWS)

6.Reinstall the sprayhead by turning it clockwise. Hand tighten only!

FIG 12

FIG 11

Page 13	40410	092407

Image 13

Contents Series BUNN-O-MATIC Commercial Product Warranty Introduction ContentsUser Notices CE Requirements Electrical RequirementsVolt CE Model 120/240 Volt Model 120 & 230 volt ac modelsPlumbing Hook-Up Plumbing RequirementsInitial SET UP Do not USE Faucet During Brew Cycle Coffee BrewingSmall Brew Switch Enable Brew ON/OFF SwitchLarge Brew Switch Operating Controls Silver SeriesRestore Factory Defaults Brew Volume SET-UPProgramming Silver Series Optional Pulse Brew SET-UPBrew B Switch + Brew a SwitchOperating Controls Smart Wave with Display DEA B CProgramming Smart Wave with Display U7 Factory Adjustments Do notAdvanced SET-UP Technician SET-UPDeliming Cleaning Optional Large Sprayhead CleaningTop Cover Cover RemovalDraining Tank Program Switches Switch SettingsKEY # Function OFF Function on Display Description Action TroubleshootingSingle Phase Wire + GNDSchematic Wiring Diagram Schematic Wiring Diagram Wave 15 APS, 15 S APS