FARGO electronic S000256 manual Cleaning the Card Feed Rollers continued, Step, Procedure

RESTRICTED USE ONLYFARGO Electronics, Inc.

Cleaning the Card Feed Rollers (continued)

Step	Procedure
4	a.	Insert the Cleaning Card into the Card Hopper, above the Card Input Tray,
		as normally done with any other type of card.
	b.	Be sure, however, that the shortest non-adhesive end of the Cleaning
		Card enters the Printer first and that the sticky side is facing UPWARD.
			Caution: If the card is inserted with the sticky side facing downward,
	it will stick to the Card Input Tray and will not feed.
5	Once the Cleaning Card is properly inserted into the Card Hopper, hold down
	the On/Cancel button and push the Cleaning Card into the Printer until the
	second gray feed Roller grabs and begins feeding the card.
6	a.	Continue to hold down the On/Cancel button until the Cleaning Card has
		fed completely through the Printer.
	b.	Repeat this cleaning procedure as needed.
	c.	After the cleaning procedure is finished, re-install media, close the
		Printer's Top Cover, and turn the Printer power OFF and ON to reset the
		Printer.
7	Be sure to use either clear tape or masking tape. (Note: If the cleaning kit is
	not available, adhesive tape is also an effective method for removing lint and
	debris from the Rollers.)
			Caution: Do not use duct or strapping tape. These adhesives leave
	a gummy residue behind.
8	a.	Open the lid, and use the Pause/Resume and On/Cancel buttons to
		rotate the main feed Rollers, while applying the tape.
	b.	Alternatively, use 99% pure alcohol wipe. Do not use these wipes for
		every cleaning because this could eventually deplete the tact from the
		Roller’s rubber.
	(Warning: Do not use alcohol to clean the Cleaning Roller Assembly.)

Persona→ C25 Card Printer User Guide (Rev. 4.0) 134