RESTRICTED USE ONLY | FARGO Electronics, Inc. |
Section 4: Cleaning
This section deals with the Printer’s internal and external maintenance in regards to the unit's cleaning and general upkeep. The Printer should be cleaned on a regular basis to insure that the Printer consistently produces high quality output.
Danger: Be sure to disconnect the Printer's power cord whenever performing any type of maintenance procedure unless otherwise directed.
Safety Messages (review carefully)
Symbol | Critical Instructions for Safety purposes | ||
|
|
|
|
Danger: | Failure to follow these installation guidelines can result in death or | ||
|
|
| serious injury. |
|
|
| |
|
|
| Information that raises potential safety issues is indicated by a warning |
|
|
| symbol (as shown to the below). |
|
|
| • To prevent personal injury, refer to the following safety messages |
|
|
| before performing an operation preceded by this symbol. |
|
|
| • To prevent personal injury, always remove the power cord prior to |
|
|
| performing repair procedures, unless otherwise specified. |
|
|
| • To prevent personal injury, make sure only qualified personnel |
|
|
| perform these procedures. |
|
| ||
Caution: | This device is electrostatically sensitive. It may be damaged if | ||
|
|
| exposed to static electricity discharges. |
|
|
| |
|
|
| Information that raises potential electrostatic safety issues is indicated |
|
|
| by a warning symbol (as shown to the below). |
|
|
| |
|
|
| • To prevent equipment or media damage, refer to the following |
|
|
| safety messages before performing an operation preceded by this |
|
|
| symbol. |
|
|
| • To prevent equipment or media damage, observe all established |
|
|
| Electrostatic Discharge (ESD) procedures while handling cables in |
|
|
| or near the Circuit Board and Printhead Assemblies. |
|
|
| • To prevent equipment or media damage, always wear an |
|
|
| appropriate personal grounding device (e.g., a high quality wrist |
|
|
| strap grounded to avoid potential damage). |
|
|
| • To prevent equipment or media damage, always remove the |
|
|
| Ribbon and Cards from the Printer before making any repairs, |
|
|
| unless otherwise specified. |
|
|
| • To prevent equipment or media damage, take jewelry off of |
|
|
| fingers and hands, as well as thoroughly clean hands to remove oil |
|
|
| and debris before working on the Printer. |
|
|
|
|
Persona→ C25 Card Printer User Guide (Rev. 4.0) | 130 |
|
