FARGO electronic S000256 manual Selecting the Pause for Low Ribbon option

RESTRICTED USE ONLY FARGO Electronics, Inc.

Selecting the Pause for Low Ribbon option

Use this option to generate a definitive warning when the print ribbon is running low. (Note: When this option is selected, the Printer will beep, pause, and the Ready LED will flash when approximately 10 to 20 prints remain on the print ribbon.)

Step Procedure

1Replace the ribbon and press the Pause/Resume button to continue printing with a new ribbon.

OR

Leave the existing ribbon in the Printer and press the Pause/Resume button.

•Once the Pause/Resume button is pressed, the Printer will continue printing until the end of the ribbon, but will beep once before each print job.

•It will not be necessary to press the Pause/Resume button again to continue printing once it has been pressed initially during a batch print.)

•The Printer will still beep once before each print job when approximately 10 to 20 prints remain on the print ribbon; however, the Printer will not pause. Instead, it will continue printing until the end of the ribbon, without User intervention.

Persona→ C25 Card Printer User Guide (Rev. 4.0) 98