Bunn 40410.0000G service manual Switch Settings, Program Switches, KEY # Function OFF Function on

Page 16

SWITCH SETTINGS

1. Unplug the brewer and let it cool down before proceeding.

3.Remove the left rear cover.

4.Flip the dip switches as needed.

NOTE: All switches are turned OFF from factory.

	KEY #	FUNCTION - OFF	FUNCTION - ON
4.	High altitude	Set temp 200°F (93°C)	Set temp 190°F (87.8°C)
3.	Energy Save	No energy save mode	Drops to 140°F (60°C) @ 6 hours/OFF @ 26h
2.	Brew lockout	Brew @ any temp	Only brews when it indicates ready
1.	Program lockout	Programming allowed	All programming locked out

FIG 15

FIG 16

1 2 3 4

OFF

Page 16	40410	092407

Image 16

Contents Series BUNN-O-MATIC Commercial Product Warranty Introduction ContentsUser Notices Electrical Requirements CE RequirementsVolt CE Model 120/240 Volt Model 120 & 230 volt ac modelsPlumbing Requirements Plumbing Hook-UpInitial SET UP Coffee Brewing Do not USE Faucet During Brew CycleEnable Brew ON/OFF Switch Small Brew SwitchLarge Brew Switch Operating Controls Silver SeriesBrew Volume SET-UP Restore Factory DefaultsProgramming Silver Series Optional Pulse Brew SET-UPBrew a Switch Brew B Switch +Operating Controls Smart Wave with Display DEA B CU7 Factory Adjustments Do not Programming Smart Wave with DisplayAdvanced SET-UP Technician SET-UPDeliming Cleaning Cleaning Optional Large SprayheadCover Removal Top CoverDraining Tank Program Switches Switch SettingsKEY # Function OFF Function on Troubleshooting Display Description ActionWire + GND Single PhaseSchematic Wiring Diagram Schematic Wiring Diagram Wave 15 APS, 15 S APS