Font installation procedure

Cut a 10mm

1.	Position the Font template (provided) on the bench area. Ensure the
	position you select is within the length of the supply tube and USB cable
	fixed to the Tap Head Assembly. These cannot be extended.
2.	Check again for correct positioning. The supply hoses must have
	constant fall back to the tank assembly. Cut the holes as shown on
	the template.
3.	Once holes are cut, locate the Font base in position, from the underside,
	lightly tighten the securing rod with the nut and washer provided.
4.	Now take the Tap Head Assembly and remove the fixing nut, washer and
	“Spider Clamp” from the “All Thread”. Apply a light smear of silicon
	sealant to the underside of the black base ring, this will provide a water
	tight seal against the Font base when clamped.
5.	Feed the hoses and USB cable through the Font base, then through the
	plastic spacer that sits under the font base but on the bench top, this

slot for stud

Tap assy

stops warping of the base plate. Ensure the Tap spout is directly centered

hole 38mm

Fixing stud

Hole required for Font

Black ring

Spider clamp

All-thread

over the Font drain. Refit the “Spider Clamp”, nut and washer onto the “All

Thread”. Have all the supply tubes and USB cable located evenly between the

Spider Clamp legs. When satisfied with the positioning, tighten the fixing nut

with the Tube Spanner provided in the kit.

NOTE: The “All Thread” is a “floating” component, it locks into place once

6. Tighten the securing pin so the Font base is flush with the bench top.

NOTE: The fixing nut above the drain elbow can be loosened to correctly

position the direction of the elbow. Ensure when the re-positioning is

complete the nut is re-tightened to ensure a water tight seal.

7. Connect a drain hose (22mm ID) from the Font base outlet elbow to the

closest drain trap spigot available. If a spigot is not available use the snap

8. Ensure the positioning of the snap-on spigot is on the “sink” side of the

trap and not the “waste” side. Once positioned, a hole (13mm ID) will

need to be drilled to provide waste access to the drain line. The snap-on

unit will require suitable sealant to keep it water tight against the waste

pipe. Finish by fitting the worm drive clamps tightly on either side of the

spigot and fitting worm drive clamps to either end of the drain hose. The

drain hose from the Font must have constant fall

9. Connect the Tap head Assembly supply hoses and vent as per the instructions

contained in the installation procedure section of this document.

Page 8 0f 20

Zenith Hydro Tap Installation and Operating Instructions - 81467 - February 2005

fixed to the Tap Head Assembly. These cannot be extended.